Sony Ericsson / Sony : Technical : Technical questions.
>
New Topic
>
Reply<
Esato Forum Index
>
Sony Ericsson / Sony >
Technical
> Technical questions.
Bookmark topic
Would this be expensive tho? Thanx in advance;-)
This post was posted from a T68i
--
Posted: 2002-10-20 10:22:00
Edit :
Quote
Practically this isn't possible. I trust you aren't a high level sw dev at SE?? You have to completely rewrite the whole sw core and then some... I said it was technically and theoretically possible, but I wouldn't bother to think about the possibility to do it. Buy a P800 when it comes...
--
Posted: 2002-10-20 10:33:00
Edit :
Quote
Well afaik the R5A software introduced limited support for WCSS, so some things are indeed usefull to read of... I'd like to know he they extended the support for WCSS in R5C...
This post was posted from a T68i
--
Posted: 2002-10-20 13:22:00
Edit :
Quote
I'll check it out...
--
Posted: 2002-10-20 19:51:00
Edit :
Quote
Thanx
--
Posted: 2002-10-20 23:03:00
Edit :
Quote
Sorry, tried to dig it up for you but the only info that are available for me is concerning the HW type i.e radio controlling etc..
--
Posted: 2002-10-21 09:19:00
Edit :
Quote
Any idea why Bluetooth comms via Bluetrek's Headset is so muffled?
--
Posted: 2002-10-21 16:57:00
Edit :
Quote
oh well, I'll try to find out what's new manually, thanx anyway
--
Posted: 2002-10-21 23:57:00
Edit :
Quote
Can you please provide complete pin layouts (not only data ones) for both Ericsson 688 and t39 phones? Could you contact me by e-mail
gunku@dati.lv for more info?
--
Posted: 2002-11-04 15:54:00
Edit :
Quote
fregor, I have one question for you - I really hope you can help me, because my operator nor Ericsson service didn't.
I have T65 (R5A010 firmware) and GPRS enabled. It works well for wap. I have also limited access to internet - special APN with access to 2 web pages of my operator - it's just for testing, but I think I will be able to browse also other pages. But I have problem that I'm not able to connect.
I have Windows XP, modem driver for T65. I have made the RS232 cable itself, but it works for SMS download, phonebook and other staff. I set-up dialup connection using this modem, dialing *99***1# (APN for internet is stored as CID=1 data profile). Windows sends ATD... command to phone and phone displays "Connecting..." on its display. One second later, it returns "CONNECT" to PC without any other parameters. Windows thinks it's connected and tries to send PPP packets. After some time it ends up with timeout and hangs-up. The problem is that phone even doesn't try to communicate with network - I have put it near radio and it was just silence. I tought it can problem with my cable, so I tried to connect using CSD wap - and I was succesful, Windows connected 9.6kbps and also got an IP address over PPP. So the cable is OK in my opinion.
I also tried a lot AT commands directly in HyperTerminal - using AT commands reference for T68. I was able to connect using that APN (AT+ACT or +ATT, don't remember now) and the phone also got IP address. But the problem is that the phone was connected (and had IP address), not the PC.
Can you please help me with this? I would really appreciate it...
Thanks...
--
Posted: 2002-11-07 13:47:00
Edit :
Quote
New Topic
Reply
