Sony Ericsson / Sony : Accessories : Is my new HPM-70 screwed or is this how it's supposed to be?
>
New Topic
>
Reply<
Esato Forum Index
>
Sony Ericsson / Sony >
Accessories
> Is my new HPM-70 screwed or is this how it's supposed to be?
Bookmark topic
Yeah but the cord to the left ear is much shorter than the one in the picture. I, like many other people have the right ear cable pretty tight, so the splitter is lower than it should be. It could be solved easily by having a moveable splitter! Damn these people. Having said that, it doesn't keep me awake at night.
--
Posted: 2006-08-10 17:37:10
Edit :
Quote
mate, good you aren't gonna lose sleep over it, since it's not a problem.
I've used mine for many months without any sign of it breaking. I use mine without feeding the right bud around the back of my head - the splitter is almost completely reversed, but it's still going strong
--
Posted: 2006-08-11 01:02:52
Edit :
Quote
it's the black-one the correct one. If you can make a neck support it will be ok .. if not , be carefull .
--
Posted: 2006-08-11 03:42:43
Edit :
Quote
What I meant is exactly what lukealexander said... it's not that I was wearing from the FRONT; I use it from behind my neck, but it puts pression in the left-earbud-cable...
In any case; any clues why my original HPM from the w800 came with the neck support and this new one not? Don't they make them like those anymore? What's up?
Also, I got the black ones, since they were the only ones in the store (they didn't had the silver)... it doesn't match the phone, right? Should I trash them and find some grey ones?
In any case, I think the cable and fastport connector look better than the silver one, specially matching the ICE-25 case...
Thanks.
--
Posted: 2006-08-11 05:17:25
Edit :
Quote
interesting, sorry I misunderstood you. I tried looping the right earbud around the back, but when I turn to the left the right ear bud pulls out! When I place the whole cable behind me (down my back) the left earbud pulls out.
So I guess either configuration is out for me. I use the headset while riding, and need to be able to turn any direction without the headset pulling out. Also, I need the mike clipped to my lapel so I can answer calls without stopping.
Standard config works for me (cable down front, both earbuds fed from the front).
--
Posted: 2006-08-17 03:57:53
Edit :
Quote
Mine are like that too.
--
Posted: 2006-08-17 13:05:50
Edit :
Quote
Well mine are the same as the black drawing. here's my solution: Slide the clip all the way up against the mic, then clip it to your shirt on the height of about where your shoulder bone meets upper chest, this will support the mic and give slack to the left earphone's wire. Then toss the right side's earphone around the back of your neck. Problem solved!! Refer to illustration. The Red on the collar is where the clip AND Mic should sit.
_________________
GH337->T10s->T630->P800->K700i->K750i->W800i->W810i
[ This Message was edited by: *dust* on 2006-08-27 22:05 ]
--
Posted: 2006-08-27 23:03:11
Edit :
Quote
Mine are like those aswell. I wonder why SE did that, considering even the most expensive earphones have a design in which both the left and right wires are the same length
--
Posted: 2006-08-28 11:33:47
Edit :
Quote
New Topic
Reply
