Sony Ericsson / Sony : Technical : Convert a data/service to a service/data cable
>
New Topic
>
Reply<
Esato Forum Index
>
Sony Ericsson / Sony >
Technical
> Convert a data/service to a service/data cable
Bookmark topic
Hi,
I bought a data cable for Ericsson . The difference between the schemes on the top is that this cable have only 3 wires. 1st conected to 4th pin, 2nd to the 5th and the 3rd to the 10th. The 9 pin is missing (i see the spot but there is no pin there) . So - i changed 1st wire to the 6th, 2nd to the 7 , and 3rd to the 11th.
In the guide above i see 4 wires.
I didn't tried , and yet, didn't bought credits . Any ideeas if it will work?
The error wih multiserver is: 0x002B00 - error oppening serial port.
[ This Message was edited by: oneill on 2004-10-26 04:57 ]
--
Posted: 2004-10-25 18:38:08
Edit :
Quote
Will this work for any SE data cable or just the T28? Will it work for my T610 data cable for instance?
BTW very nice guide ivc and theslugger
--
Posted: 2004-10-26 05:41:16
Edit :
Quote
-an aftermarket T28 cable is an unlock cable
-any other aftermarket SE cable, or SE's own serial or USB cable, is data cable
Do the conversion as per the instructions
--
Posted: 2004-10-26 19:20:58
Edit :
Quote
Damn.. u know this for certain? Howcome just the T28 aftermarket?
--
Posted: 2004-10-27 12:10:50
Edit :
Quote
If i have a t28 cable can i unbrand a T610 by myself and upgrade the firmware ?
What bout upgrading the firmware of the k700 ?
--
Posted: 2004-10-27 12:16:35
Edit :
Quote
Hi Guys...has anyone yet converted a DRS-11 cable from Data to Service?
Opening the "Phone-End" connector its a pretty buzy area with all the RS232 parts on same PCB..I'm enclosing a couple of photos just is case y have not seen it yet...seems like a straight forward deal to do the re-soldering though...
[ This Message was edited by: xatnep on 2004-10-29 19:10 ]
[ This Message was edited by: xatnep on 2004-10-29 19:12 ]
[ This Message was edited by: xatnep on 2004-10-29 19:13 ]
--
Posted: 2004-10-29 20:08:16
Edit :
Quote
I tried, but it wouldnt work.
I just switched the pins like in the scheme by soldering wires.
Multimeter says all good, but phone isnt recognized.
Guru help needed here !!
--
Posted: 2004-10-30 17:54:25
Edit :
Quote
@xatnep
I have an cable just like you,I ripped off the pin connector 4 and 5 from the PCB, put an wire from 4->6 and 5->7. and connected 9 and 11 with an wire,
flashed an z1010 with that cable without any problem with totalserver,
but was not able to unlock the phone. just got error.. very strange
[ This Message was edited by: rekan on 2004-10-31 18:52 ]
--
Posted: 2004-10-31 19:51:02
Edit :
Quote
Does the T-28 cable fit into a T610?
--
Posted: 2004-11-03 14:37:26
Edit :
Quote
yes
--
Posted: 2004-11-04 23:57:52
Edit :
Quote
New Topic
Reply
