>
New Topic
>
Reply<
Esato Forum Index
>
Sony Ericsson / Sony >
General
> Call me stupid, but how do you remove the SIM?
Bookmark topic
And its the same "mechanism" on T68!
_________________
- mrNoodles -
Technican @ Ericsson AB (formerly ERA)
Nice weekend to all of you

[ This Message was edited by: mrNoodles on 2002-03-24 21:51 ]
--
Posted: 2002-03-24 21:50:00
Edit :
Quote
well nice... but ?!?! why do u wanna get the SIM out?! I just get it out when i wanna change my phone or my SIM
--
Posted: 2002-03-24 21:58:00
Edit :
Quote
Im sure he wanna switch between T66 and T68
or other GSM phone.
most peeps have more than 1 phone
--
Posted: 2002-03-24 23:40:00
Edit :
Quote
I have two SIM cards, one for work and one private, so I switch SIM cards rather often. It's a good thing that it is possible to keep the card not in use on top of the active one behind the battery. I think that works on the T68's too. It's a pity that the phone doesn't have two SIM sockets, which could be selected programmatically. I don't like the solutions available as battery replacements, which switch each time you turn on/off the phone. There are times when I would like to have both SIMs active, and the solution with two phones is too expensive and takes too much space in my pockets.
[ This Message was edited by: altemyr on 2002-03-25 00:01 ]
--
Posted: 2002-03-25 00:00:00
Edit :
Quote
on my T68 i just slide a calling card or anything flat that's thin enough to go underneath the SIM (from the small opening where you slide it in) and then i clip my fingers above the SIM so i can pull it out
--
Posted: 2002-03-25 00:27:00
Edit :
Quote
I can never get the SIM card out. I have ti use a knife..
--
Posted: 2002-03-25 00:33:00
Edit :
Quote
"STUPID"
--
Posted: 2002-03-25 00:51:00
Edit :
Quote
use a knife man? lol
I just make others do it for me. saves me a whole lot of time, and i didn't know sim cards were hard to break, i was just afraid of breaking mine.
--
Posted: 2002-03-26 12:53:00
Edit :
Quote
ferrarista44 Posts: > 500
What i do is i get a piece of paper, any piece of paper, fold it til it's strong enough to go under the sim. And then just slide the sim out over the piece of paper.
Should take u only a second to take it out.
This post was posted from a T68
--
Posted: 2002-03-26 13:21:00
Edit :
Quote
whoa!!

a knife?? hehe..
that's exaggeratin things a bit.. hehe
--
Posted: 2002-03-28 15:12:00
Edit :
Quote
New Topic
Reply