>
New Topic
>
Reply<
Esato Forum Index
>
Sony Ericsson / Sony >
Technical
> infra red
Bookmark topic
the pc beeing old has nothin to do with it.
As a suggestion chech the bios if the ir-setting is enabled for that internal port
--
Posted: 2002-05-16 22:11:00
Edit :
Quote
Yes its enabled as internal port 2 (Irda). Any more ideas? Ed
This post was posted from a T68i
[ This Message was edited by: edwardm on 2002-05-16 21:47 ]
--
Posted: 2002-05-16 22:15:00
Edit :
Quote
In fact in infra monitor on windows it comes up with error 45 - internal error
This post was posted from a T68i
--
Posted: 2002-05-16 22:20:00
Edit :
Quote
the error may br related to your setup for irDA. You may need to set the port settings to FIR(fast infrared) from SIR (slow...)
You may need to set these options on the BIOS.
Below is information which may help you solve your pc problem?
good luck!
____________
When you double-click the Infrared tool in Control Panel, you may receive the following error message: Internal Error 45: Your infrared software has encountered an error, check infrared software settings under network properties.
CAUSE:
This behavior can occur if the Fast Infrared Protocol is missing or damaged.
RESOLUTION
To resolve this behavior, remove and then reinstall the Fast Infrared Protocol. To do so, follow these steps:
1. Click Start, point to Settings, and then click ControlPanel.
2. Double-click Network.
3. In the list of installed network components, click Fast Infrared Protocol, and then click Remove.
4. Restart your computer when you are prompted to do so.
5. Click Start, point to Settings, and then click Control Panel.
6. Double-click Network.
7. On the Configuration tab, click Add.
8. Click Protocol, and then click Add.
9. In the Manufactures box, click Microsoft, click Fast Infrared Protocol in the Network Protocols box, and then click OK.
10. Click OK, and then restart your computer when you are prompted to do so.
MORE INFORMATION:
If you install an infrared device in Windows 98, the Fast Infrared Protocol is not installed by default. You must manually add the protocol in Network properties.
--
Posted: 2002-05-17 01:56:00
Edit :
Quote
whats the ideal Ir speed for T68?
My laptop finds my little grey until i want to sync or transer files it f**ks up.
anyone able to help?
--
Posted: 2002-05-17 17:30:00
Edit :
Quote
9600 kb-pr.sec,..that works fine (SIR-seriel infrared).
Jan
--
Posted: 2002-05-17 20:07:00
Edit :
Quote
Macman> Cheers will give it a try!
Ed
--
Posted: 2002-05-17 21:58:00
Edit :
Quote
New Topic
Reply
