Sony Ericsson / Sony : Software, Firmware and Drivers : (vFinal_rev5) AudioPhile Premium HD Acoustics for All A2 & UIQ3 Phones
>
New Topic
>
Reply<
Esato Forum Index
>
Sony Ericsson / Sony >
Software, Firmware and Drivers
> (vFinal_rev5) AudioPhile Premium HD Acoustics for All A2 & UIQ3 Phones
Bookmark topic
I used Clear. I just updated my firmware so before I reinstall your drivers I'll pay a bit more attention to the default ones. Hopefully I'll notice the difference
--
Posted: 2009-09-25 15:52:23
Edit :
Quote
What phone and headphone did you use? Did you upload csv?
I use HPM-85, big-sized headphones, and there is clear differences in "1. Clear" and "3. Bass." But there is a little difference in "2. Loud", aside from the volume
Hiron
--
Posted: 2009-09-25 17:28:10
Edit :
Quote
Before the second time I uploaded acoustics I listened to certain songs on default drivers and than on your acoustics. There was slight difference mostly in realism of the sound. I did everything like in the instructions, so yeah csv file also.
I have C901 and the most basic headphones that came with the phone.
--
Posted: 2009-09-25 22:21:22
Edit :
Quote
I am new to acoustic drivers. So this driver is no use if I only play my music on my C905 loud speaker?
--
Posted: 2009-09-27 18:18:21
Edit :
Quote
@volume100, thanks for the info
@bryan84,
I'm sorry, but the answer is yes..
Hiron
--
Posted: 2009-09-28 00:19:28
Edit :
Quote
On 2009-09-28 00:19:28, Hiron wrote:
@volume100, thanks for the info
@bryan84,
I'm sorry, but the answer is yes..
Hiron
Alright thanks!
--
Posted: 2009-09-28 03:42:13
Edit :
Quote
@Bryan,
you're welcome
@all, v4 is up. Rather than uploading customize_upgrade.xml, it's better to port this patch to your phone
;T700 SW-R3EA037-MAIN-CHINA
;Remove the limitation of the maximum (8) and minimum (-8) values in the manual equalizer
;© MaPkiZzz aka Vital
;(p) adekbiroe
10c3126c: EDD3 C046
10c312c4: 72D0 C046
Hiron
--
Posted: 2009-10-06 15:59:51
Edit :
Quote
Oh man there's an issue with phf_jack_play closedair version.its no longer stereo. One channel is routed to both the channels. So another channel is absent this issue is present only with mh700 Handsfree which has mic and call end buttons. This issues isn't present in normal 3.5mm headset. So please fix it. I'm sure
There are some parameters which controls channels equalization specifically for hpm700 and normal 3.5mm jack.
Btw: I did.nt test this behavior with open air version. I'll tell you tomorrow.
[ This Message was edited by: idumbakumar on 2009-10-06 17:47 ]
--
Posted: 2009-10-06 18:34:26
Edit :
Quote
@idumbakumar,
HPM-77 and MH-700 shares exactly the same setting in play mode! It has difference in phf_jack_rec.wbxml but I didn't edit it...
Btw, had you tried to play a bit with a jack connection? Maybe tighten it or rotated it a bit? (both in phone and mic connection)... I remember experiencing that when my jack connection is somewhat not tight
If you still experience it, try to switch to original or OpenAir phf_jack_play to see whether the problem is resolved. If it's resolved, then I couldn't understand what had happened.. Just use original jack wbxml or listen with fasport while I trying to figure out what had happened..
Hiron
--
Posted: 2009-10-06 19:48:51
Edit :
Quote
Version 4.0! Too bad I dunno how to patch phones haha. I'll try them out later, if I'm still using a W715.
--
Posted: 2009-10-07 00:06:39
Edit :
Quote
New Topic
Reply