Sony Ericsson / Sony : Software, Firmware and Drivers : Modded Camera Driver For K850 By Strong v1.5 Beta2 NEW
>
New Topic
>
Reply<
Esato Forum Index
>
Sony Ericsson / Sony >
Software, Firmware and Drivers
> Modded Camera Driver For K850 By Strong v1.5 Beta2 NEW
Bookmark topic
On 2009-03-17 12:29:40, strong wrote:
@edenpunyo
open the camdriver0.dat with notepad and find the lines below
there are at the begining
the bold value is your request
change the 00 to 01 or 02,03,04 etc
// CUSTOMIZATION ZONE BY USER//
//===================NORMAL======================//
SHOT_SPEED= 1D; // 1D is default Normal shot speed
EXPOSURE=$-5 09; // Adjust exposure
BRIGHTNESS= 00; // Adjust brightness
CONTRAST= 00; // FF to 08 adjust contrast
SHARPNESS= 02; // 00 to 08 adjust sharpness
SATURATION=
00; // 00 to 08 adjust saturation
[ This Message was edited by: strong on 2009-03-17 11:31 ]
Strong busy with K850i, plz do sometuing about c902 cam drivers as well...
--
Posted: 2009-03-17 17:28:51
Edit :
Quote
// CUSTOMIZATION ZONE BY USER//
//===================NORMAL======================//
SHOT_SPEED= 1D; // 1D is default Normal shot speed
EXPOSURE=$-5 09; // Adjust exposure
BRIGHTNESS= 00; // Adjust brightness
CONTRAST= 00; // FF to 08 adjust contrast
SHARPNESS= 02; // 00 to 08 adjust sharpness
SATURATION=
00; // 00 to 08 adjust saturation
[ This Message was edited by: strong on 2009-03-17 11:31 ]
[/quote]
Dear Strong,
Thanx for the support. Really appreciated it.
--
Posted: 2009-03-18 12:14:01
Edit :
Quote
Hello everyone,
I have one question to Strong... is there an easy possibility to bring back standart video resolution? I've noticed that since brazzuka's resolution changes had been implemented, videos animation seems to have lost smoothness (decrease in fps).
P.S. Thank You, Strong, U have been doing a great job so far
[ This Message was edited by: jaycobs on 2009-03-19 08:31 ]
--
Posted: 2009-03-19 09:27:42
Edit :
Quote
On 2009-03-19 09:27:42, jaycobs wrote:
Hello everyone,
I have one question to Strong... is there an easy possibility to bring back standart video resolution? I've noticed that since brazzuka's resolution changes had been implemented, videos animation seems to have lost smoothness (decrease in fps).
P.S. Thank You, Strong, U have been doing a great job so far
[ This Message was edited by: jaycobs on 2009-03-19 08:31 ]
standard video resolution and non-forced flash will be included in final version
--
Posted: 2009-03-19 12:34:43
Edit :
Quote
hi,
i noticed that in v1.4Beta2, the file sizes are smaller... is it being compressed? i get 1.3mb to 1.9mb
--
Posted: 2009-03-22 10:03:24
Edit :
Quote
yes i decreased the size
--
Posted: 2009-03-22 21:43:34
Edit :
Quote
A very good ideea. After all, 3 MB for a 5 MP picture is too much.
Strong, I hope you'll make a good driver. Please try to decrease the noise as much as possible.
[ This Message was edited by: TimeWriter on 2009-03-22 22:13 ]
--
Posted: 2009-03-22 23:13:06
Edit :
Quote
i've tested the cam driver edited by pohuman, still think that strong's driver is the best! esspecially in full auto mode =)
--
Posted: 2009-03-23 01:16:54
Edit :
Quote
Strong's camdriver is good, but only thing I don't like is the GUI refresh rate when navigating through camera settings, the Viewfinder slows down, in brazuka's v6.0 camdriver, the viewfinder becomes very fast when navigating through camera settings. I also like what pohuman did with v6.0 of brazuka's, "beach & snow" mode is now the night mode, so night mode now has autofocus + 2 seconds exposure time + ISO64
But aside from these, I like strong's camdriver more than others, especially in outdoors + daylight
I hope in the next following versions of strong's camdriver, strong will improve night mode, with 2 seconds exposure time and low ISO (ISO100 OR lower will be great) and reduce the default flash ISO and use the "red-eye reduction" mode for forced flash, not auto mode.
[ This Message was edited by: nnr3 on 2009-03-23 16:38 ]
--
Posted: 2009-03-23 17:24:03
Edit :
Quote
brazuka and pohuman's drivers kept giving me the application error... so after using it for awhile, i got fed up =(
--
Posted: 2009-03-23 23:47:42
Edit :
Quote
New Topic
Reply
