>
New Topic
>
Reply<
Esato Forum Index
>
Sony Ericsson / Sony >
Software, Firmware and Drivers
> De-Brand UR K800i!
Bookmark topic
I am seriously thinking about de-branding my K800 using this site, but how will i get the settings for the 3's wap homepage as its good for the free stuff lol. Is this possible? Had a look at the site on the last post, but im from the UK and the site did not make any sense what so ever to me
--
Posted: 2006-07-15 19:38:44
Edit :
Quote
Quote:
On 2006-07-15 19:38:44, UnholySinner wrote:
I am seriously thinking about de-branding my K800 using this site, but how will i get the settings for the 3's wap homepage as its good for the free stuff lol. Is this possible? Had a look at the site on the last post, but im from the UK and the site did not make any sense what so ever to me
Here are the Three setting you will need to put back in
Go to Connectivity
Data Communication
Data Accounts
New Account
PS Data
Give it a name - Three
APN - three.co.uk
Save
Edit
Password Request - Off
Allow Calls - Automatic
IP Address - Blank
DNS Address - Blank
Authentication - Tick Normal, Secure and None
Data Compression - Off
Header Compression - Off
Go to Connectivity
Data Communication
Internet Settings
Internet Profiles
New Profile
Name - Three WAP
Connect Using - Three (named earlier)
Save
Highlight and Select More
Settings
Internet Mode - Http
Use Proxy - No
Save
Highlight and Select More
Advanced
Change Homepage
Name - 3 Services
Address -
http://mobile.three.co.uk/hb/K800i/HutchKey (case sensitive)
Save
Go to Connectivity
Data Communication
Internet Settings
Internet Profiles
New Profile
Name - Three MMS
Connect Using - Three (named earlier)
Save
Highlight and Select More
Settings
Internet Mode - WAP
IP Address - 217.171.129.2
Security - Off
Username - (blank)
Password - (blank)
Save
Highlight and Select More
Advanced
Change Homepage
Name - MMS
Address -
http://mms.um.three.co.uk:10021/mmsc
Save
Go to Connectivity
Data Communication
Streaming Settings
Connect Using - Three
Use Proxy - No
Save
Go to Connectivity
Data Communication
Internet Settings
Internet Profiles
Select the Three WAP profile
Go to Messaging
Settings
Picture Message
Validity Period - Network maximum
Read Report - On
Delivery Report - On
Content Alert - On
Auto Download - Always
Accept Messages - (Select All)
Message Server -
http://mms.um.three.co.uk:10021/mmsc
Internet Profile - Three MMS
--
Posted: 2006-07-15 21:35:41
Edit :
Quote
excellent, thanks very much!
--
Posted: 2006-07-16 00:55:27
Edit :
Quote
Hello
Can you not just go to se website and get your network settings re sent to your phone?
Regards
Lee
--
Posted: 2006-07-16 02:01:56
Edit :
Quote
just to let you guys know before trying this -I could not flash my phone kept getting a runtime error ,contacted wotan support and they said that my 256mb ram was not enough memory and that you need about 512mb in order for decryption of the file.
--
Posted: 2006-07-16 17:24:24
Edit :
Quote
This is my first post on the boards, I decided to flash my K800i based on the information in this thread!
I have (had!) a UK '3' network branded phone. This was some of the most horrible branding I had ever seen on a phone, it almost made me resent the absolutley fantastic deal i managed to get out of them!! Who in their right mind would put an advertising banner on the front of a phones main screen!!
Anyway, onto the guts of the post.......
Firstly, I used the tool at
www.wotanserver.com. I don't know if the DaVinci Team's tool is any better?? This meant that I had to install the USB flash drivers, which are available at the above address.
I bought a credit for the software, by logging into paypal and sending 7 euros (about £4.50ish) to the appropriate email address. Waited 30-40mins and I had an ftp login name and password.
I loaded up the tool, plugged the usb cable into the computer, and then plugged the phone into the computer while pressing and holding 'c' on the phone. The phone was found as a new device and i located & installed the correct flashing drivers which i downloaded earlier in this post. After installation was complete i unplugged my phone. It would not boot now, however removing the battery for 10 seconds sorted this little problem out!
I removed the sim card, replaced the battery, then plugged the phone into the cable while pressing and holding 'c' on the phone. I pressed start on the wotanserver tool, and it connected to my phone, I could now release the 'c' button.
I ensured that the correct region was selected (europe 2 uk, in my case), entered the ftp login information that i recieved via email, checked the finalise box (very important!) and hit the flash (start?) button!!
10 minutes later I had a nice de-branded phone
I filled in all the data & communications information as per the above post on this page. I now have a lovely de-branded K800i on the UK '3' network!!!
The '3' homepage works great through the new PlayNow main menu item. I have not tested mms capabilities though....
Thanks for all your help guys, this worked great!
--
Posted: 2006-07-17 09:13:08
Edit :
Quote
Hi there, i have an orange branded k800i, and really want to rebrand as the icons on the main menu are horrid! has anyone else on orange done this successfully? I just want to be sure that it will work safely and all buttons and functions etc will work properly! Cheers
--
Posted: 2006-07-20 11:39:12
Edit :
Quote
I tried it a few days ago, K800i branded by Swedish 3, worked great, and I can use it for all 3 services just as before. I just had to enter the settings available on their site. I like the phone much better now, unbranded.
--
Posted: 2006-07-21 00:31:14
Edit :
Quote
If you need to re-brand you can probably change your CDA back to the original and do an update from SEUS (this might mean you have to flash with an older firmware using davinci or similar to force SEUS to update).
--
Posted: 2006-07-21 16:56:53
Edit :
Quote
I have now use wotanserver and it work exelent. My phone was branded from "3" sweden.
--
Posted: 2006-07-21 21:11:04
Edit :
Quote
New Topic
Reply
