Sony Ericsson / Sony : Software, Firmware and Drivers : W810 Firmware Details and Bugs
>
New Topic
>
Reply<
Esato Forum Index
>
Sony Ericsson / Sony >
Software, Firmware and Drivers
> W810 Firmware Details and Bugs
Bookmark topic
Quote:
On 2006-08-05 21:52:45, bico wrote:
Quote:On 2006-08-03 10:13:45, DIFference wrote:
Question: Have anyone noticed that the siglan goes up and down lot? Maybe it is just my appartment. Or meybe som bug in the firmware I have? I have noticed that the phone is sensitive, it shows every little change in signal.
Yes, I have. I think it has something to do with Telia. When I am abroad, in Greece or Spain for example, the signal meter normally hardly moves at all.
_________________
/
bico
http://bico.se
[ This Message was edited by: bico on 2006-08-05 20:55 ]
I guess it is. Outside is never a problem, except for at areas with known bad siglnal. Some guy said that w810i have had a lot of problems with bad radio parts, so that people have had to send them in on the warranty. But if that is the problem then the signal should be unstable when the phone lying still on a spot i think.
Is it common that small areas like 10x10x10 cm can have much lower signal than just outside that area?
[ This Message was edited by: DIFference on 2006-08-06 18:46 ]
--
Posted: 2006-08-06 18:10:32
Edit :
Quote
have noticed the signal go up and down quite a bit on o2 uk too. SOmetimes have no signal when others do on same network in same area
--
Posted: 2006-08-06 23:54:36
Edit :
Quote
Quote:
On 2006-08-06 23:54:36, docmagoo2 wrote:
have noticed the signal go up and down quite a bit on o2 uk too. SOmetimes have no signal when others do on same network in same area
I wonder if it is a W810i issue or if it just is that it has very sensitive monitoring of the signal.
--
Posted: 2006-08-07 11:02:24
Edit :
Quote
I have a w810i on o2 uk, often when receiving calls from people the phone's screen will go white for a few seconds or just show the background for a while before showing the incoming call alert. The phone will also randomly reboot when i try to make calls
This message was posted from a WAP device
--
Posted: 2006-08-07 15:32:33
Edit :
Quote
What firmware version does your phone have?
--
Posted: 2006-08-07 18:45:14
Edit :
Quote
R4CE012
This message was posted from a WAP device
--
Posted: 2006-08-08 01:03:55
Edit :
Quote
Ok. As far as I know that particular firmware version should (normally) not cause the problems that you describe.
But an upgrade would (probably/hopefully) not hurt. Go for R4DB005.
Good luck!
--
Posted: 2006-08-08 20:10:00
Edit :
Quote
had r4ce012 on my o2 810i orginally and only suffered from the light flashing
after it had been on for a while (30 to 60 seconds), but no call problems.
Went via wotanserver to r4db005 and light problem gone away and if any-
thing the signal is more stable - usually 4 to 5 bars all the time.
--
Posted: 2006-08-08 21:22:19
Edit :
Quote
FYI I updated to R4DB005 via SEUS on O2 UK last week. CDA 102494/56 R2A cxc1250324 Europe_2. The OTA (over the air) update reports R4CE012 as being the latest on O2 so you have to update via a PC.
I wish they would sort out the OTA update service as the option is a bit misleading if it always reports whatever firmware you have installed as the latest.
Morpheus
--
Posted: 2006-08-09 01:58:08
Edit :
Quote
I have the latest version w810 and everything works great its original unbranded .
This message was posted from a WAP device
--
Posted: 2006-08-09 05:17:52
Edit :
Quote
New Topic
Reply
