>
New Topic
>
Reply<
Esato Forum Index
>
Sony Ericsson / Sony >
Software, Firmware and Drivers
> K850 Firmware Overview
Bookmark topic
On 2008-03-17 20:16:49, larry 68 wrote:
@Dart5
I also keep getting the flash sync problem since i upgraded to 031 its very annoying.
this isnīt a fw problem, i never get this in 029,037 and 031.
It can be produced because the sensor near the flash isnīt clean or you put your fingers near the sensor too.
On 2008-03-17 22:53:47, darrengf wrote:
On 2008-03-17 18:47:11, killsta wrote:
How come two exact same phones with the exact same FW, upgraded at the exact same time, have two different options?
Have they the same CDA?
[ This Message was edited by: lord_neno on 2008-03-17 21:58 ]
--
Posted: 2008-03-17 22:56:57
Edit :
Quote
this isnīt a fw problem, i never get this in 029,037 and 031.
It can be produced because the sensor near the flash isnīt clean or you put your fingers near the sensor too.
yes it is - I've made sure I haven't put my finger over the sensor since that was first mentioned months ago and if it was dirty every picture would come out dark
--
Posted: 2008-03-17 23:15:27
Edit :
Quote
Somebody help me fix this nice problem!!
That BROD has pissed me off so much now, it's got to be against the law to sell something and not tell people about it's faults. I apparently have to lose my phone for 2 weeks to get it fixed... GRRRRRRRRRRR
Any ideas?!
--
Posted: 2008-03-17 23:34:27
Edit :
Quote
If you have warranty send it in, if not; flash it with 3rd party software.
--
Posted: 2008-03-17 23:55:31
Edit :
Quote
I'm not waiting 2 weeks for my phone to be fixed whilst I'm paying Ģ35 a month to use it..
I just tried with DaVinci, paid.. and it got half way through then it just stopped.
I can't charge the battery enough to get it to actually work.. it just sits with a red light on the power button.
It'll charge half way then just started dimming again and such.. GRR
--
Posted: 2008-03-18 00:18:40
Edit :
Quote
@Dewgel,
just turn it off by removing its battery and after insert it again,plug in it in the charger without pressing any buttons!Leaving it there for about 2,5 hours.Then,plug it in the computer and start the process with DaVinci or KulanKendi...
I had the same problem and this happened due to low battery...
--
Posted: 2008-03-18 00:36:52
Edit :
Quote
try to reflash with davinci or kulankendi
--
Posted: 2008-03-18 02:45:48
Edit :
Quote
Any idea what is causing the phone to reboot with FW 031?
--
Posted: 2008-03-18 03:02:23
Edit :
Quote
mmm did you try to do a master reset or reflash it?,
my k850 had reboots with fw037 but with e031 it works so good.
--
Posted: 2008-03-18 03:08:45
Edit :
Quote
On 2008-03-17 17:49:42, Trojan Shore wrote:
I recently debranded my rogers k850, and I was wondering if anyone who has also completed this conversion would be able to supply me with the WAP (Go Rogers) Internet, and MMS (Rogers Media) settings they have used to get the browsing and picture messaging functions working again.
Thanks
Either check on this thread here ...
http://www.esato.com/board/vi[....]ic=61728&start=255#post2261820
last page OR goto SE's site under Phone Support and have that site send it as a WAP Push message and save it dirctly to your phone. Set Java Apps and internet in your phone to Go Rogers (WAP) else you'll screw yourself with huge data charges.
--
Posted: 2008-03-18 05:41:57
Edit :
Quote
New Topic
Reply
