News Forum Phone database

> New Topic
> Reply
< Esato Forum Index > Sony Ericsson / Sony > Software, Firmware and Drivers > Super camera driver for k750/w800/w810 Bookmark topic


--
Posted: 2007-10-23 00:57:06
Edit : Quote


well b4 i upgrade to 9.2 is dat some sort of glitch in 9.0 dat cause so much noise in nite mode??

ok juz update to 9.2, yes the noise is been reduce a bit but still a lot using default settings in night mode
any help??



petty good when it is bright


[ This Message was edited by: whatsucka on 2007-10-23 06:26 ]

[ This Message was edited by: whatsucka on 2007-10-23 07:18 ]
--
Posted: 2007-10-23 04:54:58
Edit : Quote


@Strong

offcourse i can..

k750@w800 r1bd001 cid49 red

oh. when u realise 5.6 camdriver??

--
Posted: 2007-10-23 08:31:17
Edit : Quote



Ok, I hope I am not spamming the thread, but the only way I found to remove noise without killing details is using noise remover software. I have written a guide about this, check here: http://www.esato.com/board/viewtopic.php?topic=156756
--
Posted: 2007-10-23 15:30:13
Edit : Quote


Sorry about this out-topic question: Does anyone what is the highest score can we get in QuadraPoP when we start with lvl9? I played with lvl 9 and my highest score stops at 99999. Thank you.
--
Posted: 2007-10-23 17:34:17
Edit : Quote


Is there a way to set a fixed ISO value using Raider's driver? I want to try "The ultimate exposure computer" from http://www.fredparker.com/ultexp1.htm .
--
Posted: 2007-10-23 17:59:25
Edit : Quote



Ridersky Drivers will try to give the lowest ISO possible, so in the absolute majority of cases it will give you ISO 100. Eventually it can give different ISO but only if you try something not practical (like shooting indoors with 1/5000 shutter speed). Also it can give ISO 80 on w810. So you can assume ISO 100. I have made a small reference card, check my posts.
--
Posted: 2007-10-23 18:12:21
Edit : Quote


Thanks for your reply, I've already made some prints with the EV tables. Tomorrow I'll go and make some photos.

[ This Message was edited by: F-Lexx on 2007-10-23 18:12 ]
--
Posted: 2007-10-23 19:12:06
Edit : Quote


On A4A code...

EM= $p1 0d
$c1 00
$p1 0e
$c1 00
05 01 00 23 01 $f $r2 1 1
$m0 1 $/0 28
$c0 00
$m0 1 $/0 03
$c0 00
$cl
$s0 3e $-0 r1
#CMDEM(04,$w0)
$cx
$cx
$cx
$cx;

I guess this value is for exposure time... or is for shutter speed? or is the same? I've seen 3d, 3e, 3f and 40 in this value
Which value is supposed to give less noise? and how affect this to exposure? cause i'm getting too much noise.
--
Posted: 2007-10-23 19:20:21
Edit : Quote


is shuter speed and value 40 is for less noise
--
Posted: 2007-10-23 19:41:32
Edit : Quote

---

New Topic   Reply

Forum Index