>
New Topic
>
Reply<
Esato Forum Index
>
Sony Ericsson / Sony >
Software, Firmware and Drivers
> Recovery mode questions
Bookmark topic
Each time when I start a SEUS I update in recovery mode, SEUS tells me that I should first run a automatic mode.
In fact that's what I already did. Does any of you know a trick to force the recovery mode to run?
The exact message is "Recovery mode can be used only if this service has been used with this particular device before" and it appears after I pressed the 'c' key following the dialog "Hold down the 'c' key on your phone and connect it to your USB cable. Please wait...."
The phone I try to recover is a D750i. I hope to deploy the recoverymode in order to get the full version of the original branded firmware back on it. All other attempts failed. A restore of my Sonics readout does not work, apparently because the readout was made after the device was switched on once. The Davinciteam firmware is for the K750i despite it is named after D750i and a normal SEUS update in automatic mode is only incremental
The phone has bad reception and I want to send it in for repair, that's the whole point
/JockyW
--
Posted: 2005-12-14 20:42:13
Edit :
Quote
Tell your problem clearly
This message was posted from a Nokia
--
Posted: 2005-12-16 16:50:08
Edit :
Quote
Quote:
On 2005-12-16 16:50:08, mamtaj wrote:
Tell your problem clearly
This message was posted from a Nokia
Err ok, one more try then
With SEUS1 I'd like to do an update in "recovery mode". When the applet starts it prompts me to press "c" and connect the DCU-60 cable to the phone. After connecting the phone it comes a message "Recovery mode can be used only if this service has been used with this particular device before". Despite I have used the service on the same PC in "automatic mode" before.
The question is how can I overcome this and run an update in "recovery mode" ?
/JockyW
--
Posted: 2005-12-16 18:49:22
Edit :
Quote
New Topic
Reply
