>
New Topic
>
Reply<
Esato Forum Index
>
Sony Ericsson / Sony >
Symbian phones
> Case for the P910
Bookmark topic
Does anyone knows a case (Silicone or otherwise) for the P910 that:
- That makes possible to use the SE car holder without removing the case?
- Is specially designed for use with no flip?
--
Posted: 2006-02-02 18:02:16
Edit :
Quote
the sillicon case wont work with the hch37, i know, but it does work with the universal SE mount, hch 30 or 32, not sire which. another down with the sillicon case is that oif you get a tiny piece of grit in it between the phone and case, i know this too, it holds it in place and continually grinds away in the same spot.
--
Posted: 2006-02-02 19:39:26
Edit :
Quote
Thanks for confirming my suspicions about the silicon case + HCH37
Unfortunately I already have the HCH37 in place (and wasn't cheap), so I'm still seaching for alternative cases.
Do you think a silicon case could be cut in a way that it doesn't interfere with the HCH37, but still gives a good amount of protection?
--
Posted: 2006-02-02 19:47:37
Edit :
Quote
no, the hch37 touches the sides and end as you know, it just won't work. the silicon case is not the grippiest fit either after a short while, it can slide easily on the phone .not because of the 'fit', but because there is little friction between the phone and case due to the materials used. i have on occasion, not often, pulled the case from my pocket leaving the phone still in my pocket because there is not a lot of sillicon case under the phone because of the connector.
--
Posted: 2006-02-03 00:56:40
Edit :
Quote
Thanks for all the insights.
Do you think it's possible to super-glue some rubber to the sides of the phone so that it becomes less slippery?
I mean, in a way that it doesn't look bad?
I find myself dropping the phone too often
--
Posted: 2006-02-03 11:37:00
Edit :
Quote
New Topic
Reply
