>
New Topic
>
Reply<
Esato Forum Index
>
General discussions >
Other manufacturers
> N5210 charger voltage
Bookmark topic
I have an old Nokia 5210 which lacks a charger. I tried with charger from and old Nokia 3210 but it didn't charge.
What charger voltage should I use?
I have a separate multicharger that can deliver up to 20Volts but that seems a bit too much.
Please help!
--
Posted: 2006-12-06 09:52:45
Edit :
Quote
As far as im aware the charger from your 3210 should work on the 5210. Are you sure the phone definately works? Have you left the charger plugged in for quite a long time and seen if there was any change?
--
Posted: 2006-12-06 10:29:39
Edit :
Quote
I left it on charge over night but the phone didnt seem to take any charge.
I suppose the phone, the battery or both are dead then
You dont know the voltage of the charger?
The 3210 charger could be dead.
_________________
T68i
R8A015+
MCA-25+
BS AX[ This Message was edited by: floke on 2006-12-06 09:34 ]
--
Posted: 2006-12-06 10:33:20
Edit :
Quote
I don't think the problem lies with the voltage cos I've been using my Nokia chargers interchangeably in the past. It sure seems like 1 or more of your 3 devices is dead.
--
Posted: 2006-12-06 10:54:00
Edit :
Quote
Thanx.
I measured the output voltage of the N3210 charger without a phone coonected and it says approximately 10V. Is that OK?
--
Posted: 2006-12-06 12:36:38
Edit :
Quote
output on my ACP 12x says 5.7V....
fatreg
--
Posted: 2006-12-06 14:49:51
Edit :
Quote
what fone is ACP12 for?
--
Posted: 2006-12-06 16:40:34
Edit :
Quote
I charged the phone overnight with some 6V and in the morning it started. It seems like the charger for N3210 ACP-7E was either brokwe or delivering to low voltage for N5210.
--
Posted: 2006-12-08 09:43:55
Edit :
Quote
New Topic
Reply
