>
New Topic
>
Reply<
Esato Forum Index
>
Sony Ericsson / Sony >
Software, Firmware and Drivers
> SEUS problem
Bookmark topic
hello,
not a long time ago i bought w850...
now i have r1gb001 fw on it...
when i try to update it on FOTA it says that i have the last fw...
and i decided to update it through SEUS.
the program starts...
and when it tells me to press C and connect the cable...
it doesn't identify my phone...
i remove sim card, replace battery, press C, connect a cable to phone...
and software have no reaction...
anyone can help me to rule out of this situation???
--
Posted: 2007-03-12 19:34:28
Edit :
Quote
Welcome to Esato first of all.
Then to your question.
You should use search on this subject. Because you're not the first one with this problem.
But still very welcome.
--
Posted: 2007-03-12 21:21:38
Edit :
Quote
the problem is that computer found and installed w850 usb flash driver...
but the software doesn't continue to do anything...
--
Posted: 2007-03-12 23:39:21
Edit :
Quote
Well like I said use search here. The phone been out on the marked for a while so what makes you think you're the first one with this problem?
One fast one though: Firewall?
--
Posted: 2007-03-13 10:02:21
Edit :
Quote
firewall turned off
--
Posted: 2007-03-13 11:11:59
Edit :
Quote
what i have...
w850 device
USB cable with usb flash drivers installed on PC
SEUS...downloaded yesterday from SE website...
new flash player and java machine...
i also remove memory stick from the phone...
but nothing happens...
while pressing C and plugging cable i also tried to press power button but still it doesn't work...
--
Posted: 2007-03-13 11:23:20
Edit :
Quote
You may have bad Fast port connection. Clean up the port and change the USB port. Try to get USB Flash driver from
http://www.wotanserver.com and install it as it is an .exe file. When SEUS asks you to hold C, just do it, then plug your DCU-60. There must be a new Found Wizard pop up. Click not now, browse to C drive to get USB flash driver folder. Then Click Continue. Voila!
If problem persists, take out battery, repeat the above procedure until your phone is recognised in Flash mode. Always take out battery in every attempt. Hope it helps.
Also, while holding C, adjust the cable in such a way, in case you have loosen pins. I got the same problems with my K800i and had to repeat the procedure until 5-7 times! My DCU-60 pins have loosen off a bit so I had to work harder LOL. Changing USB ports is also advisable. And restarting the PC or Add new hardware manually from Control Panel is worth a try. Good luck, mate.
[ This Message was edited by: aremaboy on 2007-03-13 13:06 ]
--
Posted: 2007-03-13 13:58:00
Edit :
Quote
thank you...
i updated the phone but the FW is still r1gb001
is something wrong???
--
Posted: 2007-03-13 18:35:36
Edit :
Quote
is your phone branded by the operator that you bought it from?
--
Posted: 2007-03-13 18:53:56
Edit :
Quote
no it's not branded...
--
Posted: 2007-03-13 22:05:59
Edit :
Quote
New Topic
Reply
