>
New Topic
>
Reply<
Esato Forum Index
>
Sony Ericsson / Sony >
Symbian phones
> Remove P900 Housing
Bookmark topic
Help guys, The top has broken off my stylus and it's stuck in the holder, is there an easy way to get this out or do I have to dismantle the housing? Could somebody point me in the right direction about removing the case if so, there are no obvious screws under the battery or anything...
xXx
--
Posted: 2007-04-06 18:51:12
Edit :
Quote
http://www.uselessinfo.pwp.blueyonder.co.uk/dismantlep900.htm
Could try this... pics are not brilliant... but may help
--
Posted: 2007-04-06 19:00:09
Edit :
Quote
dismantling the housing, as far as i know, would not allow you access to the stylus compartment as it is a seperate compartment and the only way to acess it is through the top (where u usually take out ur stylus from), prob send it bak if its under warranty, and say the stylus was crap quality, or u might have to change your entire housing, im pretty sure some folks have some experience regarding the P990 housing, and not too long ago there was a thread posted with pics by this guy who had attempted to repair his scroll wheel, just try searching the forum, u might find something.
--
Posted: 2007-04-06 19:03:06
Edit :
Quote
On 2007-04-06 19:03:06, mobilemodman wrote:
dismantling the housing, as far as i know, would not allow you access to the stylus compartment as it is a seperate compartment and the only way to acess it is through the top (where u usually take out ur stylus from), prob send it bak if its under warranty, and say the stylus was crap quality, or u might have to change your entire housing, im pretty sure some folks have some experience regarding the P990 housing, and not too long ago there was a thread posted with pics by this guy who had attempted to repair his scroll wheel, just try searching the forum, u might find something.
In some ways you are correct ... the stylus compartment is still in tact once you have dismantled the housing... but there are slots/opening that you maybe able to move the stylus end upwards and it could fall free..
But there would be no reason to change the whole housing...
I had to take mine apart a couple of times to replace the housing due to the weak point under the keypad....
--
Posted: 2007-04-06 19:43:16
Edit :
Quote
If you don't like those pictures there is a roughly equivalent guide for the p910 that I wrote here on Esato.
http://www.esato.com/board/viewtopic.php?topic=93264&start=0
The phones are a little different, but mostly the same as far as pulling them apart is concerned and you should be able to follow my guide and figure out the little differences yourself.
The stylus is actually stored in the rear housing after disassembly and you will be able to push it out without too much trouble. My photo at Step 6 show the rear housing and the stylus sits in a channel in the upper part of that photo.
--
Posted: 2007-04-07 03:22:42
Edit :
Quote
Nice one Knight....
Those pics are alot clearer...
--
Posted: 2007-04-07 03:34:25
Edit :
Quote
New Topic
Reply
