>
New Topic
>
Reply<
Esato Forum Index
>
Sony Ericsson / Sony >
Technical
> W800 Right Softkey Not Working
Bookmark topic
Well i just changed my front casing and now my right softkey won't work. I tried my keypad in my mums w800 and it worked fine.
I got it working for about an hour earlier and but i dunno how.
I checked that the connection on the keypad and it's fine.
Can anyone suggest anything?
--
Posted: 2007-06-21 23:07:00
Edit :
Quote
hey, lon time no see. since
Loosing patches when updating firmware
try to put the housing again and look if it works
--
Posted: 2007-06-21 23:20:23
Edit :
Quote
Is it a genuine fascia? The non-gen ones tend to be a poor fit meaning some buttons don't work.
Try loosening the screws slightly, i've found that helps with stiff/non functioning buttons, u may need 2 experiment with how much u loosen them.
--
Posted: 2007-06-21 23:27:00
Edit :
Quote
Yeah its been to long, i tried it.
On 2007-06-21 23:27:00, Sammy_boy wrote:
Is it a genuine fascia? The non-gen ones tend to be a poor fit meaning some buttons don't work.
Try loosening the screws slightly, i've found that helps with stiff/non functioning buttons, u may need 2 experiment with how much u loosen them.
Yeah its genuine. Just tried that, didn't work.
Any other ideas?
--
Posted: 2007-06-21 23:33:27
Edit :
Quote
dirty or dust. check out if the right soft key isnt damaged physically or something.
--
Posted: 2007-06-21 23:38:03
Edit :
Quote
On 2007-06-21 23:38:03, tranced wrote:
dirty or dust. check out if the right soft key isnt damaged physically or something.
But it worked in my mum's W800.
--
Posted: 2007-06-21 23:45:34
Edit :
Quote
so the problem is with your board maybe.
--
Posted: 2007-06-21 23:49:34
Edit :
Quote
On 2007-06-21 23:49:34, tranced wrote:
so the problem is with your board maybe.
Yeah thats what i was thinking, i just really don't want to buy a new phone.
--
Posted: 2007-06-21 23:55:18
Edit :
Quote
I have similar problem when I tried to open the housing for the first time. Actually I wasn't changing the housing, I just needed to clean the joystick... But after I put the expensive things together again I got no light on my keyboard and some keys not working. As you mentioned the keyboard was working fine in another W800, you just need to check the connection where the keyboard is connected to the mainboard. The housing you tried to apply maybe is not genuine and that's causing the problem, but after all a genuine housing can cause it too if it is placed wrong. So if the connector with the board is the problem (and it seems like to be...) try pushing the connection between the mainboard and the keyboard a little, but be VERY careful not to damage it. Give it a little closer contact and try if it works.
See the picture below:
And ignore the numbers on the picture... it is from a dismantling K750 manual
.
--
Posted: 2007-06-22 00:04:08
Edit :
Quote
or the right softkey button fits on too tightly onto the keypad contacts...
--
Posted: 2007-06-22 03:00:00
Edit :
Quote
New Topic
Reply
