>
New Topic
>
Reply<
Esato Forum Index
>
Sony Ericsson / Sony >
Symbian phones
> My p990 is dead after SEUS!
Bookmark topic
the phone is brand new(2 days old) and it was working fine until i use SEUS,the program finish fine at 100% but when I power the phone it just vibrates......no wsod,no red light just vibrates.
I don't have a receipt that's why i need your help!!!
thanks
--
Posted: 2007-07-11 01:39:08
Edit :
Quote
My suggestion is Reflash the phone. Take out the battery before and after. Hope it will kick in!
--
Posted: 2007-07-11 02:51:05
Edit :
Quote
i wish you goodluck. try what above user said if not send it in to SEUS and hopefully everything will be taken care of for you. It happens to the best of us
goodluck
--
Posted: 2007-07-11 02:54:44
Edit :
Quote
You don't have a receipt for a two day old phone?!!
--
Posted: 2007-07-11 04:57:01
Edit :
Quote
Residentevil Posts: > 500
Try the recovery mode option.
--
Posted: 2007-07-11 05:02:56
Edit :
Quote
Don't have a receipt,and whats the recovery option?
thanks
--
Posted: 2007-07-11 05:09:54
Edit :
Quote
have you ever charged it (2 days old..) before flashing ?
could be that there isn't enough power left to start up..
charge it for a while and check what happens..
--
Posted: 2007-07-11 21:21:27
Edit :
Quote
it was charged 100 percent when i run the update i think my phone is dead for good,anybody interested in buying it for parts or maybe to fix it.
DAMN SEUS!!!
--
Posted: 2007-07-13 01:55:15
Edit :
Quote
Is your phone not covered by warranty?
Did you buy it off Ebay, which is why you don't have a receipt?
--
Posted: 2007-07-14 15:03:07
Edit :
Quote
On 2007-07-13 01:55:15, chrisperro wrote:
it was charged 100 percent when i run the update i think my phone is dead for good,anybody interested in buying it for parts or maybe to fix it.
DAMN SEUS!!!
It is 99.99% unlikely that your phone is a brick or paper weight yet. As the did not start after firmware update, peoblem should be with the firmware (actually it is bugware) not the hardware though there is 0.01% probability for hardware failure assuming that you went through the correct procedure.
--
Posted: 2007-07-14 15:21:47
Edit :
Quote
New Topic
Reply
