Sony Ericsson / Sony : Symbian phones : Dropped my P1i - housing a little misshapen
>
New Topic
>
Reply<
Esato Forum Index
>
Sony Ericsson / Sony >
Symbian phones
> Dropped my P1i - housing a little misshapen
Bookmark topic
Any recommendations?
[ This Message was edited by: tombertram on 2007-11-24 19:52 ]
[ This Message was edited by: tombertram on 2007-11-24 19:54 ]
[ This Message was edited by: tombertram on 2008-04-28 16:43 ]
--
Posted: 2007-11-24 20:47:40
Edit :
Quote
its not the taking apart that is hard
its the putting together
--
Posted: 2007-11-25 01:31:16
Edit :
Quote
@tomb - I don't THINK that hammering it will have it contoured back
Better start canvassing for a CHEAP fascia in an
store pal . . . Good Luck !
--
Posted: 2007-11-25 02:05:22
Edit :
Quote
Temporarily you could file or cut the protruding piece away so it doesnt get caught on your clothes, I would try that, but beware of cutting through though.
--
Posted: 2007-11-25 10:06:07
Edit :
Quote
On 2007-11-24 20:47:40, tombertram wrote:
Dropped my brand new p1i ...
I did exactly the same. Just se a cloth to pu it over the aluminium fascia and use a tool to bend it back in place. The aluminium is very soft but you can't bend it with your bare hands.I did just that.
--
Posted: 2007-11-25 11:10:11
Edit :
Quote
Cool thanks, what sort of tool would you recommend? A hammer? Also is there any paint I can go over the scratches with?! Thanks! Tom.
On 2007-11-25 11:10:11, 701 wrote:
On 2007-11-24 20:47:40, tombertram wrote:
Dropped my brand new p1i ...
I did exactly the same. Just se a cloth to pu it over the aluminium fascia and use a tool to bend it back in place. The aluminium is very soft but you can't bend it with your bare hands.I did just that.
--
Posted: 2007-11-25 13:47:03
Edit :
Quote
New Topic
Reply
