>
New Topic
>
Reply<
Esato Forum Index
>
Sony Ericsson / Sony >
Software, Firmware and Drivers
> K800 setool problem
Bookmark topic
I have a problem with setool ... when i want to put a patch it give me this error :
Welcome to SEtool2 ( LITE edition ) v 1.11
supported DB2010/DB2012 CID49/50/51/52, DB2020 CID49/51/52
Loaded 51 flash descriptors
if you like LITE edition - please visit
http://www.setool.net and buy FULL.
Going to execute VKP script....
ChipID:9900,EMP protocol:0301
PHONE IS RED RETAIL PRODUCT
FLASH CID detected:52
Speed:921600
Trying to launch embedded bootloader...
INT LDR:quick access patch by den_po
FLASH CID:52 COLOR:RED
OTP LOCKED:1 CID:51 PAF:1 IMEI:35731501857564 CERT:RED
Loader not responding !
Elapsed:41 secs.
what is the problem ? :|
[ This Message was edited by: BuGaS on 2008-01-06 10:01 ]
[ This Message was edited by: BuGaS on 2008-01-06 10:01 ]
--
Posted: 2008-01-06 11:01:11
Edit :
Quote
try to do it again... maybe your usb cable is not that tight when attached to your phone... i have encountered that many times in my xs++3.1 and about two times in setool, just got lucky it did'nt screw anything on my phone...
--
Posted: 2008-01-06 18:33:28
Edit :
Quote
now i have another problem... when i press C to connect the phone at setool the phone turned on
(sorry for my english:))
--
Posted: 2008-01-06 19:07:29
Edit :
Quote
make sure that when you press c, plug the cable not more than 5-10 secs... the phone will automatically open when you hold c that much.... ok? when it commands you to hold c, then hold c... after that plug in your usb cable...
--
Posted: 2008-01-06 19:19:26
Edit :
Quote
New Topic
Reply
