Sony Ericsson / Sony : General : USB device not recognized / This device could perform faster
>
New Topic
>
Reply<
Esato Forum Index
>
Sony Ericsson / Sony >
General
> USB device not recognized / This device could perform faster
Bookmark topic
well i had this problem on my k750 but figured it was because the cable & phone were over 2 years old.. but now i got a new k850 and new DCU-60 cable with it and im getting this shitty **** problem 50% of the time.
Either it comes up with "The device could perform faster when connected to a USB 2.0 port", but it is... or "USB device not recognized". I have to reconnect the phone 5x and try different USB ports to get it fixed.
This also happens at my other computer and with the old DCU-60 cable from my k750.
The connector is clean and so is the fastport on my k850, well atleast to the eye.
Also, sometimes it'll just disconnect even though i havent even touched it.
Any solution or am just ******?
thanks
--
Posted: 2008-02-04 23:36:40
Edit :
Quote
Its because either your computer doesnt support USB 2.0 or its disabled from the bios.
--
Posted: 2008-02-05 11:58:00
Edit :
Quote
Like i said, i have USB2.0 and it's enabled..
When i reconnect it 10x it works fine
--
Posted: 2008-02-05 12:05:23
Edit :
Quote
On 2008-02-05 12:05:23, Duran wrote:
Like i said, i have USB2.0 and it's enabled..
When i reconnect it 10x it works fine
Piece of s**t.. Micro$oft Windoze, that's the problem.
--
Posted: 2008-02-05 12:49:42
Edit :
Quote
i think it's
Piece of s**t.. SE Fastport, that's the problem.
--
Posted: 2008-02-05 13:17:11
Edit :
Quote
On 2008-02-05 13:17:11, Duran wrote:
i think it's
Piece of s**t.. SE Fastport, that's the problem.
That would be my call as well.
--
Posted: 2008-02-05 13:23:40
Edit :
Quote
@duran
download the driver from here and give it a try again
http://ma3.extranet.sonyericsson.com/drivers/
--
Posted: 2008-02-05 15:24:29
Edit :
Quote
i already use the drivers from that site
--
Posted: 2008-02-05 15:37:14
Edit :
Quote
U probably got a broken cable or maybe a damaged fast port due to the way u fix and remove ur charger, headset and all. Just find a way to keep it steady while u're connecting to a pc. I've been living like dat for months and I've been fine, lol. Good luck.
This message was posted from a W700i
--
Posted: 2008-02-05 16:19:18
Edit :
Quote
=(
i havent tortured the cable at all..always remove it by pulling it down etc. (like the booklet says)
--
Posted: 2008-02-05 17:19:13
Edit :
Quote
New Topic
Reply
