>
New Topic
>
Reply<
Esato Forum Index
>
Sony Ericsson / Sony >
Symbian phones
> NEED HELP! P1i debrand and update
Bookmark topic
Hey there,
I'm trying to change my CDA to World Generic 1 so I can get the latest update through SEUS. I've been combing through these and other forums for the past two days and following every tutorial i see, yet I can't seem to get it done.
My main problem is that when i load up XS++, (v3.1 Darwin) I take out the battery. sim memory card everything, reinsert the battery, hold 'c', all that stuff. The light under my device turns red, the screen goes white, and all i see is the battery on the top right hand corner (full, as instructed).
This all i get.
13:10:39| XS++ v3.1 (Darwin) Ready !
13:10:39| Executed on Microsoft Windows XP
13:11:01| Executing SEMC Smartphone Operations!
13:11:01| Please hold boot key ('@' or 'C') and connect device...
And it just seems to stay at 'Please hold boot key...' forever. Nothing happens!
The phone specs are
PHONE:
CXC 162037 R9G007
BLUETOOTH:
CXC 162143 R1C
ORGANIZER:
CXC 162108 R6D23
CDA:
CDA 162024/87 R1A
These are not on any CDA lists I've seen. From what I've googled, these digits are from Singapore.
Can anyone help me? Do I even need to go through XS? Maybe I should just update through SEUS? Although all i've heard are freak accidents and bricked phones. Seems like XS++ / SEUS is the best way to go.
What am I doing wrong here?
--
Posted: 2008-03-17 22:08:42
Edit :
Quote
Do you continue to hold 'c' after you've connected it?
Does XS++ time out after 30 seconds?
Incidentally, the latest firmware isn't available on WG1 anymore, so you'll need to make it WG2, but we've got to get it working first.
--
Posted: 2008-03-17 23:11:19
Edit :
Quote
yes, I've tried to hold 'c' before connecting, while connecting, yet XS still sits there on the message: Please hold boot key ('@' or 'C') and connect device...
forever..haha.
--
Posted: 2008-03-18 00:17:01
Edit :
Quote
its the same with me the first time..i keep holding the 'c' ok here u should do plug ur USB cable to other port..it will work....dont plug at the same port...try other port then start the program and connect .do the same thing u do.u will see new hardware found..it will work.....
--
Posted: 2008-03-18 04:36:28
Edit :
Quote
When you use XS++ you should use the following steps:
1. Check the smartphone option.
2. Remove your battery for 10 seconds and put it back in.
3. Click connect on XS++,
4. Connect your phone while holding the 'c' button until xs++ status is ready.
If this does not work make sure you have the drivers installed for the phone. Check
http://forums.se-nse.net/index.php?showtopic=16148
--
Posted: 2008-03-18 05:57:33
Edit :
Quote
press after you connected phone with cable., try use other USB port
--
Posted: 2008-03-18 12:20:44
Edit :
Quote
New Topic
Reply
