>
New Topic
>
Reply<
Esato Forum Index
>
Market >
Accessories wanted
> LF: SE IMEI Label
Bookmark topic
I recently replaced the housing of my phone and wanted to know if someone here have those special printers and can make me one for the new housing.
Thanks
--
Posted: 2008-04-01 01:17:59
Edit :
Quote
no phone repairers here? :S
need one for a w900i
--
Posted: 2008-04-04 13:05:23
Edit :
Quote
I highly doubt someone will tell you if one has it
--
Posted: 2008-04-04 14:51:00
Edit :
Quote
On 2008-04-04 14:51:00, kenoby wrote:
I highly doubt someone will tell you if one has it
lol, do they even exist for the public?
--
Posted: 2008-04-04 15:34:30
Edit :
Quote
Muhammad-Oli Posts: > 500
I would doubt it too, as it would allow scammers, thieves and people who make fakes to make up IMEIs that look real and they'd be able to scam more people, etc. And I highly doubt that any of it would be legal.
--
Posted: 2008-04-04 15:38:51
Edit :
Quote
can't you submerge your old housing in boiling water and then carefully peel it off...then glue it onto your new one
--
Posted: 2008-04-04 16:06:18
Edit :
Quote
wouldnt the boiling water remove the letters on the sticker?
--
Posted: 2008-04-04 17:39:59
Edit :
Quote
dont think so.....will have a look at one in a sec
--
Posted: 2008-04-04 17:42:22
Edit :
Quote
please do.
that would be easier then
--
Posted: 2008-04-04 17:43:58
Edit :
Quote
right....had a little look on my sisters SE.....it seems to be printed on well but am not too sure
If i were you id put a splash of boiling water on a little section of it but dont rub it in...or you could try warm but not boiling water
worst case though will be that it will rub off....you wont be able to use it on the new housing without trying so its up to you
--
Posted: 2008-04-04 18:17:18
Edit :
Quote
New Topic
Reply
