Esato Forums - Sony Ericsson / Sony : Software, Firmware and Drivers : my w810i does not get detected by the computer.PLS HELP

Index Menu

> New Topic
> Reply
< Esato Forum Index > Sony Ericsson / Sony > Software, Firmware and Drivers > my w810i does not get detected by the computer.PLS HELP Bookmark topic

toughrockk Posts: 5

Hi ther. Can any1 pls help. I hav downloaded all related files for flashing my w810i. I hav also installed the cd accompanied with the phone. (ie. the usb drivers)

After tht I switched off my phone, removed the battery for 30 sec n replaced it again, pressed 'c' and holding it connected it to my computer but still no new hardware is found. Instead the phone switches ON and the generic volume( mass storage device) gets detected. Wat should i do.... PLs help...

Thanks in advance...
--
Posted: 2008-06-22 08:59:01
Edit : Quote

jhayms Posts: 105

What OS do you use? if you were using an XP, just install SEMC flash driver. Connect your cable to phone while holding "C" on your phone. It will detect SEMC, then install the SEMC driver.

check this thread http://forums.se-nse.net/index.php?showtopic=17540

[ This Message was edited by: jhayms on 2008-06-22 08:18 ]
--
Posted: 2008-06-22 09:16:01
Edit : Quote

toughrockk Posts: 5

hi jhayms... thanx for de reply....

but i am still having de same problem... wen i connect my phone holding c... the pop up menu tht says " Found new Hadware" does not appear.

is ther any other way... Pls help.... need it badly.. thanx in advance....
--
Posted: 2008-07-02 08:44:20
Edit : Quote

pram_zx Posts: 161

hmm thats strange.....?
try to remove you battery for 5-10 second and then reconnect again with hold the "c" button, not the back button (just in case if you miss understood)

in my case, Im plug the USB cable to PC, then remove battery for a few second, put it back then hold the "c" button and connecting my phone to the USB cable that attached to my PC, and still hold the "c" button until my phone recognized with xs++ or setool2lite.

I hope it can help you.

_________________
W810i Black with W800 back cover, modded camdriver, Own mix acoustic driver, Unbranded phone, Adding new flash menu's. W810i It's Rock...!

[ This Message was edited by: pram_zx on 2008-07-02 09:00 ]
--
Posted: 2008-07-02 09:53:17
Edit : Quote

sitnet Posts: 325

HEY I also had this, try turning off the windows firewall and antivirus just for the first time you connect, for some reason my firewall blocked the new hardware wizard. There is also another way to install the drivers- just copy the driver files(ie. USBflash.dll ect.) into this directory(drive letters may vary)-C:/WINDOWS/System32/drivers

After that try connecting the phone again with XS++ or far manager.

HOPE THAT HELPED!!
--
Posted: 2008-07-02 23:19:00
Edit : Quote

strizlow800 Posts: > 500

Yeah, manually installing (copying) the drivers into system directory might work for you... There is a problem with your PC in my opinion...
--
Posted: 2008-07-03 10:55:26
Edit : Quote

toughrockk Posts: 5

thanx 4 de replies guys... it was very helpful.... de phone got detected after i formatted my system and did de above procedure...

--
Posted: 2008-08-08 19:10:58
Edit : Quote

New Topic Reply