>
New Topic
>
Reply<
Esato Forum Index
>
Sony Ericsson / Sony >
General
> k800i build questions and issues
Bookmark topic
Hi,
I have a k800i for more than a week, and i noticed that the fron panel is a bit unstable, there is a small ... i could describe it as a gap in the lower left corner of the front panel, and when being pressed it makes creacky noises. Of course the difference is lass than a half millimeter, but it is still irritating.
So i wanted to ask you if you have noticed the same issue, is there a way of fixing it, and is it normal to have such gaps in general?
I also wanted to ask you for suggestions for a case for the phone (I would appreciate photo suggestions).
thanks!
--
Posted: 2008-08-03 22:56:46
Edit :
Quote
if u were to take it apart you could do more damage. it could be from when it was made. Did u buy it with warrenty because i would send it back and get it fixed properly if not u could buy the parts off ebay.
--
Posted: 2008-08-07 12:21:18
Edit :
Quote
If you want to open your K800, check this video:
K800 dissasembly:
http://www.youtube.com/watch?v=xpv2E7iZ3-k
--
Posted: 2008-08-07 12:41:29
Edit :
Quote
My silver K800i has same thing in one corner but its nothing as the rest of the phone is solid apart from the odd creak. On each side it runs straight then on one end at the bottom its slightly off with it not being totally flush with the rest of the phones body. Its no big deal hardly notice it and affects nothing. Its not about to fall apart.
--
Posted: 2008-08-07 13:34:00
Edit :
Quote
New Topic
Reply
