>
New Topic
>
Reply<
Esato Forum Index
>
Sony Ericsson / Sony >
Software, Firmware and Drivers
> K800i Dead!
Bookmark topic
I removed the usb connection while i was doign a firmware update by accident and now my phone wont turn on at all, there is no flashing red light in the I/R port, doesnt recognize the charger or usb cable,
How can i fix this? Can this be fixed even if i give it to a mobile phone shop?
--
Posted: 2008-09-09 18:36:53
Edit :
Quote
try using xs++ or far manager or setool2 lite to re-flash ur main and FS
it happened to me..buh i just reflashed it and it wz workn normally
oh but u will lose all ur files, contacts and everything (even the stuff that u had when u bought ur phone)
--
Posted: 2008-09-09 18:40:01
Edit :
Quote
take the battery out for some seconds and then try to reupgrade
--
Posted: 2008-09-09 19:14:16
Edit :
Quote
but the usb is not getting recognized when i plug my phone in, how will it work :S
--
Posted: 2008-09-09 19:23:52
Edit :
Quote
any ideas?
--
Posted: 2008-09-10 14:14:40
Edit :
Quote
You should find a way to check battery and charge it if empty...
Next:
1/Try to clean phone`s connector
2/download
SETool Lite 1.08
3/start it
4/push "Identify" button
5/hold together 2 and 5 on phone`s keypad,
not "C"
6/plug the cable and wait a few seconds...
Now SETool must be recognize your phone...
If not...sorry...
,you need service...
[ This Message was edited by: Goldmen on 2008-12-16 19:35 ]
--
Posted: 2008-09-10 14:28:44
Edit :
Quote
dennevhyn_31 Posts: > 500
Your phone is dead.bring it to a service center.there is a problem with the systemboard of your phone.it's really going to happen if the firmware update was interrupted.it also happens in printers if the firmware update got interrupted.
--
Posted: 2008-09-20 06:51:00
Edit :
Quote
On 2008-09-10 14:28:44, Goldmen wrote:
You should find a way to check battery and charge it if empty...
Next:
1/Try to clean phone`s connector
2/search & download SETool Lite 1.08 or higher from 4shared
3/start it
4/push "Identify" button
5/hold together 2 and 5 on phone`s keypad,
not "C"
6/plug the cable and wait a few seconds...
Now SETool must be recognize your phone...
If not...sorry...
,you need service...
This is great advice. Try these steps... If not you will have to send the phone to service center... Btw, problems like this can be solved with cruiser cable (service cable) which works with external battery.
--
Posted: 2008-09-20 08:45:36
Edit :
Quote
New Topic
Reply
