Sony Ericsson / Sony : Software, Firmware and Drivers : Dead W610 .
>
New Topic
>
Reply<
Esato Forum Index
>
Sony Ericsson / Sony >
Software, Firmware and Drivers
> Dead W610 .
Bookmark topic
Hi everybody ..
I have w610 and it's suddenly stopped working, and just a red blink led shown near the turn on button ..
I searched the internet, and I tried all ways I found using setool 2 ..
I tried repair but it doesn't work ..
I downloaded the GDFS file and Main files and tried to write them into the phone but all I get is that setool stuck at that screen for a long time
and then I get this :
Can't get packet properties.
wrong response, break.
failed, that is fatal
Elapsed:373 secs.
--
Posted: 2009-01-29 19:20:57
Edit :
Quote
u should restore only ur own GDFS not other GDFS
--
Posted: 2009-01-29 19:58:49
Edit :
Quote
I think your battery has completly run out... It's not a new problem...
Put your phone on charge for the whole night or more, say 8-12hrs... Or just put it on charge and forget it for a day...
It should work after that...
--
Posted: 2009-01-29 20:05:32
Edit :
Quote
coba , I don't have them ,, what to do ?
hgautam , I already did that .. and I also tried another battery ..
[ This Message was edited by: Alsarea3 on 2009-01-29 19:35 ]
--
Posted: 2009-01-29 20:31:54
Edit :
Quote
Ouch!!!
--
Posted: 2009-01-29 20:43:15
Edit :
Quote
here try this
http://www.akshayy.com/sonyer[....]inking-dead-revive-it-to-life/
--
Posted: 2009-01-30 08:12:31
Edit :
Quote
Same, Just stopped here
and then the same error message ..
BTW I have setool2 1.08 , not 1.11 as mentioned in the tutorial ..
--
Posted: 2009-01-30 09:33:46
Edit :
Quote
anyone ?
--
Posted: 2009-01-30 15:13:13
Edit :
Quote
did u try to flash ur phone back?
--
Posted: 2009-01-30 18:01:34
Edit :
Quote
How exactly ?
--
Posted: 2009-01-31 20:56:47
Edit :
Quote
New Topic
Reply
