Esato Forums - Sony Ericsson / Sony : Software, Firmware and Drivers : K800 K800 R8BF003_RED53

Index Menu

> New Topic
> Reply
< Esato Forum Index > Sony Ericsson / Sony > Software, Firmware and Drivers > K800 K800 R8BF003_RED53_WI .unable to patch & even re-flash Bookmark topic

rsdsgd Posts: 140

Dear modders...!
I want to flash & apply patches to my K800 R8BF003_RED53_WI.
When I connected it via FAR it displays:

1. qa 2020
2. bflash
3. After clicking "bflash" after sometime the error appearsas follows:

SetDirectory (& a long detail after it..........)

This is the dead end & I've to plug out the phone. My phone is not working at all & even I'm unable to re-flash it.
If u have tips about it, i'll be happy to see.... thanx

[ This Message was edited by: rsdsgd on 2009-06-12 09:39 ]

--
Posted: 2009-06-12 10:36:18
Edit : Quote

Boysie Posts: > 500

You should have exited FAR in the correct manner, not just unplug the phone.

Is there any life in your phone and does it get detected with FAR?

This is the CID53 patching guide...
--
Posted: 2009-06-12 13:15:14
Edit : Quote

rsdsgd Posts: 140

Thanx for attention!

When I connect via FAR & click on ofs, the error appearsas :

I cant think what's ahead....!! Thanx for any assistance.

And when I click after entering "qa2020", the error appears as:

[ This Message was edited by: rsdsgd on 2009-06-12 12:57 ]

--
Posted: 2009-06-12 13:52:19
Edit : Quote

Boysie Posts: > 500

Firstly you are using the wrong script. You should be using db2020 not db2012. Second qa2020 is only used after you have patched QAPatch.

[ This Message was edited by: Boysie99 on 2009-06-12 13:44 ]

--
Posted: 2009-06-12 14:38:38
Edit : Quote

rsdsgd Posts: 140

On 2009-06-12 14:38:38, Boysie99 wrote:
Firstly you are using the wrong script. You should be using db2020 not db2012. Second qa2020 is only used after you have patched QAPatch.

[ This Message was edited by: Boysie99 on 2009-06-12 13:44 ]

Ok, thanx for assistance, but I'm confused now that from where should I start?
Will u plz give here the procedure (considering me a new beginner)...? Thanx

--
Posted: 2009-06-13 10:57:24
Edit : Quote

Boysie Posts: > 500

You should start by reading the guide in the link I posted.

--
Posted: 2009-06-13 11:10:01
Edit : Quote

rsdsgd Posts: 140

Thanx very much Boysie for ur kind attention & guiding tips...!!
It's alive again.. Hope to look at u if needed in the future.
--
Posted: 2009-06-13 19:44:49
Edit : Quote

Boysie Posts: > 500

No probs.

--
Posted: 2009-06-13 20:52:00
Edit : Quote

New Topic Reply