Esato Forums - Sony Ericsson / Sony : Software, Firmware and Drivers : My k810i cid 53 dead, ir port is blinking

Index Menu

> New Topic
> Reply
< Esato Forum Index > Sony Ericsson / Sony > Software, Firmware and Drivers > My k810i cid 53 dead, ir port is blinking Bookmark topic

Page12 >

anandbaskara Posts: 4

Hi
I have sony ericson K810i, when i tried switching on red light blinking at IR port. My K810i CID is 53, Please help to recover this phone. Have tried SEUS and no luck. have saw the below post about kulkendi and wotan, will it work for me please advise.

http://www.esato.com/board/viewtopic.php?topic=136077#post1833443

Regards,
Anand

--
Posted: 2009-07-09 14:02:35
Edit : Quote

Boysie Posts: > 500

If your battery is charged, then it has erom problem. Try KK client. Have heard it can fix eroms.

--
Posted: 2009-07-09 14:20:00
Edit : Quote

anandbaskara Posts: 4

Thanks for the response boysie, Mine is CID 53 and saw the below message in the post

. your advise is appreciated.

Press "5" and "2" keys, hold them together and plug DCU60 USB cable.
Phone Connected...
Detected: DB2020: A1 Series
Flash ID: 0x897E - Supported
Error: Unsupported CID (>52) Version!
--
Posted: 2009-07-09 14:27:11
Edit : Quote

Boysie Posts: > 500

Oh yeah, forgot that. Well you're going to have to take it to service centre I'm afraid.

--
Posted: 2009-07-09 15:13:00
Edit : Quote

anandbaskara Posts: 4

Hi I have tried kulankendi and it results in below error,

Error: EROM CP Not Accepted!

please help me in getting back my k810i

--
Posted: 2009-07-10 06:55:58
Edit : Quote

jayce07 Posts: 47

boysie,, can't he use the jdflasher ? it's the thing you suggested to me when my k800i had the same condition as he has on his phone. ryt?
--
Posted: 2009-07-10 07:11:31
Edit : Quote

Boysie Posts: > 500

On 2009-07-10 07:11:31, jayce07 wrote:
boysie,, can't he use the jdflasher ? it's the thing you suggested to me when my k800i had the same condition as he has on his phone. ryt?

And did you fix yours?

Flashing the "actual" EROM isn't possible with free software I believe. Only the FOTA part of the EROM is flashable. He needs to take it for repair.
--
Posted: 2009-07-10 08:08:22
Edit : Quote

nathan23 Posts: 57

there rnt any free ways to get it to work... i tried almost evrythin possible
Use D-Ultimate unlocker.. worked on my K810i CID 53

[ This Message was edited by: nathan23 on 2009-07-10 11:36 ]

--
Posted: 2009-07-10 12:33:28
Edit : Quote

markphil Posts: 435

Go to the nearest SE service center for repair

When it comes to service, remember that your

dealer knows your phones very well and is interested in your complete satisfaction
--
Posted: 2009-07-11 00:15:25
Edit : Quote

nathan23 Posts: 57

On 2009-07-11 00:15:25, markphil wrote:
Go to the nearest SE service center for repair

When it comes to service, remember that your

dealer knows your phones very well and is interested in your complete satisfaction

not here in india

those guys told me my board had gone.. n i gt it done at home

--
Posted: 2009-07-11 19:59:53
Edit : Quote

Page12 >

New Topic Reply