Esato Mobile
Regional : Asia Pacific : About nokia 5300 format
> New Topic
> Reply
< Esato Forum Index > Regional > Asia Pacific > About nokia 5300 format Bookmark topic
Page12>

nikkinaru Posts: 1

Help kung my alam kau code pang format
[ This Message was edited by: masseur on 2009-08-02 09:39 ]

--
Posted: 2009-08-02 09:52:00
Edit : Quote

diportivo Posts: 90

*#7780# or switch of your phone and click 3* and key green call and switch on key in the same time { 4key in the same time }

This message was posted from a WAP device
--
Posted: 2009-08-02 10:36:04
Edit : Quote

nikkinaru Posts: 1

@Diporbito
thx alot. Amm that code is that for formating or restore? And the last, is 5300 can use opera?
--
Posted: 2009-08-02 10:44:37
Edit : Quote

diportivo Posts: 90

The first code for restore ,the second for format. Yes You can use opera in your phone

This message was posted from a WAP device
--
Posted: 2009-08-02 10:51:16
Edit : Quote

Hiruwechi Posts: 0

That's n0t ganna work
c0'z s40 is n0t like s60, the best thing u can do eh go to n0kia support center st0re. Gud luck
--
Posted: 2009-08-02 11:11:18
Edit : Quote

nikkinaru Posts: 1

What! Huhuhu. Help pls the setting fr0m smart icant save it. It descard auto huhu. And i make new c0necti0n it says can't make mem0ry full but i have 2mb free help
--
Posted: 2009-08-02 11:29:18
Edit : Quote

exaflare23 Posts: 227

@nikki
dyosmiyo! Anu b pnag ggwa mo s phone mo? N5300 din cp q di q pa naencounter yan gnto nlng restore factory settings mo ung phone at alisin mo muna microSD bgo mo irestore.
--
Posted: 2009-08-02 14:19:10
Edit : Quote

j_floyd Posts: -3

i dont think those codes will work coz 5300 is an s40 phone..especially s40v3 phones have no hard format codes like *#7780#
--
Posted: 2009-08-03 04:55:35
Edit : Quote

brys182 Posts: 246

no codes needed,,, i think restore code will not work on that unit,,,
just go to your phone settings i think it's there,,,
do what brad exa posted.
--
Posted: 2009-08-03 05:08:19
Edit : Quote

litemint Posts: 252

Start, RUN, cmd
C:\\>format N5300 /q /u


--
Posted: 2009-08-03 06:11:52
Edit : Quote
Page12>

New Topic   Reply
Forum Index

Esato home