>
New Topic
>
Reply<
Esato Forum Index
>
Sony Ericsson / Sony >
General
> another dead k810
Bookmark topic
i just changed sim, then it didnt boot up anymore, have IR light blinking
i tried to update the EROM using kulankandi
Phone Connected...
Detected: DB2020: A1 Series
Flash ID: 0x897E - Supported
EROM CID Detected: 52
Status:3
EROM Update Ok!
All Done! - Time:00:00:19
took out cable, battery, re-inserted battery
still not powering up.
any other suggestions?
i tried using SETools2 lite 1.11
this is the result
ChipID:9900,EMP protocol:0301
BOOTROM MODE DETECTED
Speed:921600
OTP LOCKED:1 CID:51 PAF:1 IMEI:35945101631102 CERT:N/A
FLASH CID:52 COLOR:RED
LDR:061201 1314 HANCXC1329129_DB2020_FLASHLOADER_R2A005
Flash ID check:897E
Flash props sent ok
CSloader version:
070410 1557 HANCXC1250562_DB2020_CSLOADER_R3A009
loader startup: executed
CSloader refused to start GDFS services,error is:29
failed, that is fatal
Elapsed:8 secs.
Abort all operations.
phone pre-boot failed,possible RECOVERY needed.
Elapsed:28 secs.
i need help. thanks
--
Posted: 2009-08-20 21:02:17
Edit :
Quote
Flash it using my tutorial:
http://www.esato.com/board/viewtopic.php?topic=156090
and download software from
www.4shared.com
--
Posted: 2009-08-20 22:23:35
Edit :
Quote
last night i was able to use XS++ too, but after detecting the phone, i cant run into the other radio buttons(flash...etc)
they were grayed out. only setting is on.
then today after getting some sleep, i tried to access the phone again. using SEtool, XS++, kulankandi. this time it cant be recognized at all. PC is not showing the sony usb drive device on device manager.
you think this is the end for this?
--
Posted: 2009-08-21 04:23:09
Edit :
Quote
anybody? any idea about this?
still IR blinks but PC is not detecting anymore.
[ This Message was edited by: kaioz on 2009-08-21 13:18 ]
--
Posted: 2009-08-21 14:17:25
Edit :
Quote
Hold 2+5 when you're plugging into XS++ instead of C
--
Posted: 2009-08-21 15:10:28
Edit :
Quote
yes, that what i do whenever i tried to use it with SEtool, XS++ and kulankandi because holding C seems not to be working.. they are able to identify the phone yesterday im able to upgrade the erom but didnt help, and today nothing seems to work anymore, phone is not being detected at all.
--
Posted: 2009-08-21 17:36:23
Edit :
Quote
Residentevil Posts: > 500
Sorry to hear that. Have you tried Far manager?
--
Posted: 2009-08-21 17:50:21
Edit :
Quote
i think i will be sending the phone to SE repair center and see what they can do about it. the phone is not being recognized anymore by the PC so no use for any software to try. probably something on the hardware have to be repaired of changed
--
Posted: 2009-08-22 18:27:20
Edit :
Quote
New Topic
Reply
