>
New Topic
>
Reply<
Esato Forum Index
>
Sony Ericsson / Sony >
Technical
> how to disassemble k800 ?
Bookmark topic
how to disassemble k800??
please show full pictures..because i want to fix my k800 Camera plug inside...
thankx
[ This Message was edited by: DevilMind on 2009-11-26 10:50 ]
--
Posted: 2009-11-26 11:49:22
Edit :
Quote
Ive done this myself a few weeks ago and it was a crap casing -.- now the buttons are hard to press.
heres what you're looking for
http://www.youtube.com/watch?v=v45tg-yrd2M
just search youtube for problems next time
[ This Message was edited by: mriley on 2009-11-26 16:42 ]
--
Posted: 2009-11-26 17:41:50
Edit :
Quote
Remove the battery. Remove the 2 phillips screws that hold the back cover on. Lift the back cover off making sure the camera cover is in the closed position. Remove the 4 T6 Torx screws in each corner. Carefully lift off the centre section making sure you don't catch any of the side buttons as they are very fragile. Also when you have enough room. Unclip the 2 circuit boards holding the memory card cover cable between them. You can now completely remove the rear and middle section. Just work your way round the boards uncliping sections at a time. Takes about half an hour to completely dissassemble the phone.
This message was posted from a WAP device
--
Posted: 2009-11-26 18:20:13
Edit :
Quote
i haven totally opened & fix the camera problem my self....
but now the problem is, the small button of Camera lid in interbody s broken/work out(the Camera Eye lid button) plz tell me how to fix it now???
--
Posted: 2009-11-26 19:01:30
Edit :
Quote
Do you mean that when you open the camera lens cover. It doesn't start the camera ?
If thats the case. It will be the small switch that has broken. It cannot be replaced on its own. You have to replace the whole flash circuit ribbon. This includes the camera on/off switch, xenon flash unit and the capacitors (2 battery shaped items). There is no other way to do it. The ribbon is just plugged onto the main circuit board and is lightly glued in place's. Very easy to remove if you take your time and are careful. You will find a good quality replacement part at www.cnn.cn and at a good price as well.
This message was posted from a WAP device
--
Posted: 2009-11-26 19:43:25
Edit :
Quote
thx for help but i can't buy any parts because these wont ship to my country
is their any way to i can fix the Swith again, because i do have the swith with me in my hand its not broken...its seems pulled out...
i did turn on cell camera was working fine..but i had to press the Switch manually by opening it to make the camera work...
one more thing:
is their a way of Taking Off the Joystick & replacing it with a D-Pad ???
thankx
--
Posted: 2009-11-26 20:20:20
Edit :
Quote
dont buy off amazon is my advice
--
Posted: 2009-11-26 20:28:15
Edit :
Quote
Could you take a picture of the part that is broken ? It may help.
If its the very small grey black arm that has come off from behind the camera lens then it cannot be put back on. If it the camera button that you press to take a picture then yes it might be fixable. Also there is no way you can replace the joystick with a d pad.
This message was posted from a C901
--
Posted: 2009-11-26 20:36:31
Edit :
Quote
i have a train now for another city, ill be back in 2-3 days & ill posts the pictures for you...because i have to leave now...
thnkx
--
Posted: 2009-11-26 20:41:00
Edit :
Quote
Ok :-)
This message was posted from a WAP device
--
Posted: 2009-11-26 21:05:09
Edit :
Quote
New Topic
Reply
