Esato Forums - Sony Ericsson / Sony : Symbian phones : P1i Update was unsuccessful

Index Menu

> New Topic
> Reply
< Esato Forum Index > Sony Ericsson / Sony > Symbian phones > P1i Update was unsuccessful Bookmark topic

harshahiriya Posts: 3

Hello everyone

I was updating my P1i from SE update service, suddenly error came like "update was Unsuccessful", now my phone is not switching on. So plz help me out from this problem........

Thanks
--
Posted: 2010-01-14 06:20:21
Edit : Quote

ryuriel Posts: 124

Go to this link,maybe it solve your problem! http://www.persian-forums.com/f78/uiq3-phones-resurrection-32992/
--
Posted: 2010-01-14 07:06:45
Edit : Quote

harshahiriya Posts: 3

Thanks for help.

--
Posted: 2010-01-14 08:54:23
Edit : Quote

harshahiriya Posts: 3

it is showing like this.
What is the problem?
--
Posted: 2010-01-14 09:12:49
Edit : Quote

ryuriel Posts: 124

1. Turn off your phone
(remove battery and place it
back) and run XS++ (!!!without
SIM card!!!)
2. Tick ‘Smartphone’ and click
Connect button
3. Press and hold on ‘C’ button
on phone and then connect
using the USB cable
4. Wait until it finish detect
your phone (show with some
green texts)
5. Smartphone Flashing:
Browse your resurrection
package (!!!DONT EXTRACT!!!
Browse ZIP file)
6. Tick ONLY Flash CCPU
7. Press Flash PDA
8. Wait... when you see
Disconnected... Unplug the
phone
9. Disconnect your phone, and
DONT TURN ON!!!!
10. Update your phone via
SEUS again

--
Posted: 2010-01-14 09:50:00
Edit : Quote

fantoms Posts: 30

A problem acquired during flashing:

19:44:24| SMARTPHONE WILL BE FLASHED IN 1 PHASE!
19:44:24|
19:44:24| [---------- PHASE 2 ----------]
19:44:24|
19:44:24| Sending db2001_cid53red_flash_r1a003.bin...
19:44:26| Applet ID: 060524 0930 LIECXC1325414_DB2000_FLASHLOADER_R1A003
19:44:26| This is a FLASH loader
19:44:26| Flashing CCPU_Signaling_SW_CXC162037_R9H004_RED53.software
19:44:26| Header type: BABE
19:44:26| 107 flashblocks
19:47:35| Finishing flash
19:47:37| Done flashing
19:47:37| Flashing CCPU_Signaling_SW_R9H004R_RED53.software
19:47:37| Header type: BABE
19:47:37| 8 flashblocks
19:48:01| Failed sending flashblock 3. Returnvalue 0x1
19:48:01| Finishing flash

Need help.

EDIT:
I have downloaded CCPU_Signaling_SW_CXC162037_R9H004_RED53 and everything with XS++ was OK but when tried to update via SEUS at 9X % there was an interruption. Flashing was unsuccessful.
Any ideas?

Is there any possibility to flash P1i by XS++ at 100%?

[ This Message was edited by: fantoms on 2010-04-17 18:25 ]

--
Posted: 2010-04-17 18:52:05
Edit : Quote

New Topic Reply