Sony Ericsson / Sony : Symbian phones : I feel I must put an end to a small rumor...
>
New Topic
>
Reply<
Esato Forum Index
>
Sony Ericsson / Sony >
Symbian phones
> I feel I must put an end to a small rumor...
Bookmark topic
This rumor is fairly unimportant.. But I have this obsession to rid the world of ignorance and I cannot let a thing like this slip...
The pins on the keypad that touch the screen are not made of metal.
I know this because I made a mark in one of them with my finger nail.
This would be impossible if the pins were made of metal.
This ofcoure does not change the fact that they are hard enough to break the display so be carefull....
--
Posted: 2003-03-05 01:15:00
Edit :
Quote
it's not impossible to mark metal with ur fingernail if it's lead!
but i'd say it's a pretty safe bet that they're not made of metal
--
Posted: 2003-03-05 14:51:00
Edit :
Quote
But..they WILL cause damage to the screen overtime if a piece of dust comes inbetween the button and the screen. Its already happened under 2 of my buttons.
--
Posted: 2003-03-05 16:59:00
Edit :
Quote
gadgetboytom Posts: > 500
use screen protectors
another way to see they arent metal is to shine light through the other side of the keypad and look at the reverse!!
light cant pass through metal!!
--
Posted: 2003-03-05 17:07:00
Edit :
Quote
I suggest you might burn the keyboard, and see if the pins melt.
If they do, probably not metal
;D
--
Posted: 2003-03-06 09:29:00
Edit :
Quote
use a magnet. just hope it doesnt mess up ur fon's internal parts.
This message was posted from a P800
--
Posted: 2003-03-06 10:04:00
Edit :
Quote
Quote:light cant pass through metal!!
Technically, isn't glass a metal?
--
Posted: 2003-03-06 14:15:00
Edit :
Quote
Glass Isnt Metal You Iddiot
--
Posted: 2003-03-06 14:59:00
Edit :
Quote
--
Posted: 2003-03-06 15:23:00
Edit :
Quote
What is glass?
Is it just glass or is it part of some group like iron is metal and water is liquid?
Naturally it isn't metal as it has very few of the attributes needed to be called metal.
--
Posted: 2003-03-06 15:46:00
Edit :
Quote
New Topic
Reply