>
New Topic
>
Reply<
Esato Forum Index
>
Sony Ericsson / Sony >
General
> T68i(problem)
Bookmark topic
Hello, i have a sony eicsson t68i and after looking at photos of how to open the phone i decided to give it a try. While i did this a big problem has now occured, i took the battery out and then the piece above(the first step) after that i realised that it was impossible for me to open the phone because i didnt have the right screwdriver! So i then put the cover back on and then put the battery back in. As i turned the phone on i didnt have a signal(where i normally have a full bar) so then i thought i'll leave it for a while and see what happens but now that ive gone back to it all it says is"No Access" so i was wondering if anybody else has had this problem and if so could you please explain to me why. I have tried turinin it on and off with no avail.
Thanks.
--
Posted: 2003-06-02 20:32:13
Edit :
Quote
check under the top piece make sure you have not damaged the circuit !! Also chk your sim is in correctly!!
--
Posted: 2003-06-02 21:12:32
Edit :
Quote
Ummm how come u wanted 2 open up ur fone in da 1st place if u don't mind me asking?!
This message was posted from a T68i
--
Posted: 2003-06-02 21:18:08
Edit :
Quote
have it repaired @ the nearest

service center in your place...& just a tip...Dont play w/ your phone
--
Posted: 2003-06-02 22:25:17
Edit :
Quote
You may have dislodged the antenna, it is only connected to with spring loaded pins. Take the antenna cover off again and check that the antenna appears to be seated correctly.
Failing that I would agree that an

service point is your next step.
Regards,
Phil.
--
Posted: 2003-06-02 23:42:37
Edit :
Quote
I did the same thing with mine phone once. Then se had to change the antenna. That was not cheap!
This message was posted from a T68i
--
Posted: 2003-06-03 00:05:09
Edit :
Quote
How much was that when u did it? The thing is i still have my warranty so could i claim on that?
Thanks
P.S I also never took off the strip, just opened it up, noticed i didnt have the right screwdriver and shut it back up again.
[ This Message was edited by: Iceblast on 2003-06-04 19:51 ]
--
Posted: 2003-06-04 20:49:30
Edit :
Quote
New Topic
Reply