>
New Topic
>
Reply<
Esato Forum Index
>
Sony Ericsson / Sony >
Accessories
> T310 Casing on a T300
Bookmark topic
I have a T300 and I was wondering if I bought a OEM full casing of a T310 phone if I would be able to screw it on to the guts of my t300. Thanks
--
Posted: 2003-07-25 04:23:06
Edit :
Quote
The t310 is slightly smaller than the t300, so I don't think it will suit.
--
Posted: 2003-07-25 12:20:12
Edit :
Quote
Pretty sure the Pcb's are the same size so it would be possible!!
--
Posted: 2003-07-28 21:29:13
Edit :
Quote
don't think it will fit, the circuit board for T300 looks a bit different in the design then T310's...
--
Posted: 2003-07-28 22:03:14
Edit :
Quote
t310:104 x 49 x 19 mm
t300:106 x 48 x 21 mm
I doubt it will fit good...
--
Posted: 2003-07-28 22:34:39
Edit :
Quote
ok to make T310 casing fit to T300, you have to at least know how the
board thickness is.
basically both phone is using same PCB design. Main different should be that T300 have changable faceplate or front housing (whatever you prefer). So T300 will have some metal and plastic in front just to protect the phone when we open up the front.
If T310 casing do compensate or consider this extra component, then you can fit it in.
width and length isn't a problem because you can see an obvious spacing at both side once you open up the front of T300 which mean the phone can be "narrower"
now the main thing for you is to find someone who have dismantle a T310 before then compare the front side of the pcb on both phone.
--
Posted: 2003-07-29 07:09:47
Edit :
Quote
New Topic
Reply
