>
New Topic
>
Reply<
Esato Forum Index
>
Sony Ericsson / Sony >
General
> How to tear a T68i apart?
Bookmark topic
Hi.
I an going to paint my T68i. How do i get my front and backcover and the sides off?
Pictures would be great!
--
Posted: 2003-08-23 18:09:55
Edit :
Quote
i would show u pictures but i hate the free pic sites
Step1 remove torx screws on the bottom
step 2 using fingernails from the top remove the antenna cover
step 3 remove other 2 torx screws
step 4 remove cover
and done
--
Posted: 2003-08-23 18:20:45
Edit :
Quote
Tis been done be4.
--
Posted: 2003-08-23 18:20:59
Edit :
Quote
First of all..u should hafta get a t6 torx screwdriver for this...
-remove that bat
-unclip the antenna cover using a bent paper clip (L-figure)
it's hooked inside...
-unscrew 4 sides (careful on screwing em back, it has 2 regular-sized ones n 2 longer ones)
-run your thumbnail through the faceplate's sides to unclip it
Still if u wanna get the mainframe dettached
-unscrew again (4 of the same size)
-remember to take the sim off
Good luck...
--
Posted: 2003-08-23 18:31:15
Edit :
Quote
ferrarista44 Posts: > 500
i believe the only problem you'll have is removing the antenna cover where 2 screws lie beneath.
Totonox's guide taught to use a paper clip bent in such a way that it "unhooks" the 2 hooking parts of the antenna cover. you'll see those hooks when you take off the batt, you wouldnt miss it.
please take note that the 2 screws under the antenna cover are longer than the 2 screws at the bottom part of the phone. some technicians interchange the screws and end up with faceplates that have weird bumps on the lower part (coz they use the longer screws and drive em all the way until it protrudes the front cover--stupid technicians)
[ This Message was edited by: ferrarista44 on 2003-08-23 17:34 ]
--
Posted: 2003-08-23 18:33:31
Edit :
Quote
[quote]
On 2003-08-23 18:33:31, ferrarista44 wrote:
i believe the only problem you'll have is removing the antenna cover where 2 screws lie beneath.
Totonox's guide taught to use a paper clip bent in such a way that it "unhooks" the 2 hooking parts of the antenna cover. you'll see those hooks when you take off the batt, you wouldnt miss it.
please take note that the 2 screws under the antenna cover are longer than the 2 screws at the bottom part of the phone. some technicians interchange the screws and end up with faceplates that have weird bumps on the lower part (coz they use the longer screws and drive em all the way until it protrudes the front cover--stupid technicians)
This is what m tryin to stress out...GJ ferrarista.
--
Posted: 2003-08-23 18:45:54
Edit :
Quote
New Topic
Reply
