>
New Topic
>
Reply<
Esato Forum Index
>
Sony Ericsson / Sony >
General
> t610 Casing Replacement
Bookmark topic
Some advice from a Guru please.
I have a new t610 and have purchased a replacement - different colour case. Comes with the special screwdriver for the screws.
The new case is in 3 parts - front - top - and rear battery cover.
The problem - how do I get the top part of the case off without damaging it. There are no screw fixings. C-Phone W-House says an Engineer uses a special tool. Is that true?
I have tried prising it at different angles to no avail.
Any advice will be warmly received
Martin
--
Posted: 2003-10-17 20:49:55
Edit :
Quote
Today i've tried this... I had to call a mate of mine at a se serv. point up, how could i remove the top case. Solution: push a small screwdriver by the cam both sides. Disconnect and push the whole plastic case. Below the case there is the anntena on a plastic plate. Remove it carefully and further you only need is a torx 6 screwdriver. Now the mine is blue. Only the frontcover... :-(
This message was posted from a T610
--
Posted: 2003-10-17 21:05:06
Edit :
Quote
this should help you.
pix included !
scroll to the bottom
http://www.esato.com/board/viewtopic.php?topic=34257&forum=2
--
Posted: 2003-10-17 21:37:44
Edit :
Quote
New Topic
Reply
