>
New Topic
>
Reply<
Esato Forum Index
>
Sony Ericsson / Sony >
General
> Up Arrow AT Command in T610
Bookmark topic
I am developing a little "chatboard" app in VB using AT commands to communicate with my T610 via a serial cable, but the T610 doesn't seem to have an AT command for the up arrow. I have tried the AT command for t68 (AT+CKPD="^") but i does not work. Does anybody have a suggestion?
--
Posted: 2003-12-27 16:16:04
Edit :
Quote
Seems that nobody knows... Sorry
--
Posted: 2003-12-28 15:12:34
Edit :
Quote
The AT command is actually documented in a official T610 AT command list so i think it might be my software version that is faulty (R3C002). Could anybody with a T610 and a serial cable send AT+CKPD="^" with the hyper terminal and write down the result and your software version? Thank you.
--
Posted: 2003-12-28 17:12:12
Edit :
Quote
How do I do that?
--
Posted: 2003-12-28 18:06:22
Edit :
Quote
you run the hyperterminal program that comes with windows (on winxp its start, all programs, accessories, communications, HyperTerminal. Make a connection to the T610 modem and in the properties, configure, advanced click on "bring up terminal window before dialling".
start a call and the terminal window will appear where you can type the AT command requested.
this probably assumes you have MPM installed etc but I cannot try it as I have no cables...
I did try it via IR and it gave the response of ERROR although other AT commands worked as expected
--
Posted: 2003-12-28 18:32:48
Edit :
Quote
I don't think you need MPM if you choose a comm port instead of the T610 cable modem.
@masseur
What software version do you have?
--
Posted: 2003-12-28 19:38:30
Edit :
Quote
sorry, forgot to mention that. R3C002 (until next week when I will upgrade)
edit: just tried it on my Z600 also with R2F002 with the same results
_________________
...Unless I'm very much mistaken[ This Message was edited by: masseur on 2003-12-28 18:44 ]
--
Posted: 2003-12-28 19:39:40
Edit :
Quote
Could you try to send the command when you have uprgraded?
--
Posted: 2003-12-28 21:21:36
Edit :
Quote
will do but I hope you have sorted you rproblem by then
--
Posted: 2003-12-28 21:24:39
Edit :
Quote
Thx
--
Posted: 2003-12-28 21:25:27
Edit :
Quote
New Topic
Reply
