>
New Topic
>
Reply<
Esato Forum Index
>
Sony Ericsson / Sony >
Technical
> T200 cable: USB or RS232?
Bookmark topic
I want to buy a data cable to connect T200 to my PC: which is the bet USB or RS232?
Which is the most supported from any software?
And for unlock software?
Thanks
Flaviano
--
Posted: 2004-01-09 00:45:14
Edit :
Quote
I use RS232, actually 4 sync, get pics etc and works fine, do like that i can charge in d same time. Reg
This message was posted from a R520
--
Posted: 2004-01-09 00:55:54
Edit :
Quote
The USB data cable is in fact a serial data cable with a built-in USB-serial adapter. So they work the same way with any software.
Some after-market USB cables can also charge the phone.
These data cables cannot be used to unlock/flash your phone. You need an unlocking cable for that. (Though technically you can re-arrange the pins of a data cable to turn it into an unlocking one)
--
Posted: 2004-01-09 19:14:57
Edit :
Quote
Quote:
On 2004-01-09 00:55:54, bobafett wrote:
I use RS232, actually 4 sync, get pics etc and works fine, do like that i can charge in d same time. Reg
This message was posted from a R520
Which is the software that you use with T200?
Thanks
--
Posted: 2004-01-16 23:32:08
Edit :
Quote
i've got a ( non-official ) usb cable for my SE T200 and nothing works right(!) and the cable's constructor supports all others phones except t200
I 've also tried my cable with "FMA" and "MyPictures" but things were bad. HAS anyone a DIAGRAM of RS232 to SE cable? I wont to try it..tnks
--
Posted: 2004-03-16 02:02:25
Edit :
Quote
check this site:
http://www.geocities.com/adoleon2000/cableSET226.htm
--
Posted: 2004-03-16 03:10:17
Edit :
Quote
You ARE THE BEST
THNKS!!!!!!!
--
Posted: 2004-03-17 00:39:37
Edit :
Quote
although I buld the serial cable nothing changed!!!! the software finds the phone but that's all nothing else works! whats wrong? Is my phone locked and do I have to unlock it?
--
Posted: 2004-03-22 19:00:04
Edit :
Quote
make sure the COM port speed is 9600 for the cable under device manager -> ports
If you are using SE software, enable the COM port under Phone Monitor Options under control panel
[ This Message was edited by: ESTOR on 2004-03-22 21:15 ]
--
Posted: 2004-03-22 22:14:35
Edit :
Quote
I' ve already done all these...(phone monitor founds my phone, and also FMA) but I can't extract any info from my phone....anyway THNKS
--
Posted: 2004-03-23 19:34:40
Edit :
Quote
New Topic
Reply
