Sony Ericsson / Sony : Software, Firmware and Drivers : problem with fma connecting
>
New Topic
>
Reply<
Esato Forum Index
>
Sony Ericsson / Sony >
Software, Firmware and Drivers
> problem with fma connecting
Bookmark topic
yesterday i got fma and i managed to connect my pc to phone on port 3, today i went to connect but it fails and i havent the slightest clue why, help
--
Posted: 2004-01-18 13:28:20
Edit :
Quote
Cable ? IR ? BT ?
--
Posted: 2004-01-18 13:42:52
Edit :
Quote
BT dongle (msi), i tried all the other ports but nothing works,
also i want to know more about the 13 second trick, will it delete my wap settings and bluetooth paired devices etc,
please answer my fma question as a first priority please
--
Posted: 2004-01-18 13:45:56
Edit :
Quote
Yez because when you do the 13sec trick you have to do a master reset and when you do that your phone will be like new. If i was you i would sync everything over to my computer before doing it.
--
Posted: 2004-01-18 13:54:54
Edit :
Quote
well im trying to but fma wont work, also how do i sync the wap/mms settings over to pc
--
Posted: 2004-01-18 13:58:22
Edit :
Quote
In your 'my bluetooth places' try connecting to the port you use (in this case port 3) and once you have gotten a bluetooth connection with your phone then open up fma. If that works then it should work everytime from then one. I found the first time I had to connect my T610 manualy then after that fma would automaticaly connect it. However when a new device was added (a z600) I had to connect the port manualy again and then after that fma would again connect to my t610 automaticaly. I hope that helps you.
--
Posted: 2004-01-18 14:39:07
Edit :
Quote
hi,
I am having trouble conecting with fma....
I have conected my t610 to the pc via a bluetooth serial port,and in the fma options i have selected the same port.But next to where it says bluetooth port,it says bluetooth address,which it automaticaly set at 00.00.00.00.00.00 ???
what is this ??
how should it be configures???
i supose that must be my problem,hense i have no problems doing a backup with other software...
thanks.
--
Posted: 2004-01-18 15:33:00
Edit :
Quote
well thanks it works now, is it possible to use fma with the T68
--
Posted: 2004-01-18 15:48:56
Edit :
Quote
the original fma was built with the t68 in mind...
but sinc its already waaay past its due date,
the developers opted to concentrate on the t610
the t68 is still supported tho, albeit a couple limitations
@folling182
you should choose "Use serial port", key in your port number and just leave the other options as it is...
should work, if anything else pops up...
you could always flip through
here or
here.
feel free to post a new enquiry
--
Posted: 2004-01-18 18:54:18
Edit :
Quote
i sorted it all out,
T68 - port 3
T610 - port 9
everythin's fine, thanks y'all
--
Posted: 2004-01-18 20:49:58
Edit :
Quote
New Topic
Reply
