>
New Topic
>
Reply<
Esato Forum Index
>
Sony Ericsson / Sony >
Accessories
> My data cable problem
Bookmark topic
I have searched a few times before starting this topic so bear with me.
I bought a data cable from eBay. I have a Z600, and when i set up the image editor it says no Z600 attached. I had installed the cable first but when I looked into the folders on the DataCable CD there was only a T610 folder but no Z600 folder. At first I assumed they would both use the same thing.
When I checked the eBay listed of what I bought iI noticed it didn't mention Z600. So I bought another that did. But this cable looks exactly the same and with no Z600 folder in the CD.
Can anyone understand/help me?
--
Posted: 2004-01-21 15:33:28
Edit :
Quote
hey i had da same problem u gotta get mobile phone monitor ok and once u instal it, go 2 control panel and enable da COM ports k i can explain more in detail later if u PM me ok
--
Posted: 2004-01-21 23:19:11
Edit :
Quote
Okay I found that other post about what to do in this case. I have the MPM, I enabled each port to check which it was. There's a small icon on my tool bar tray. There's no tick on it tho to show the phone is attached but when I flick the small switch on the USB cable it charges the phone.
--
Posted: 2004-01-22 11:41:47
Edit :
Quote
New Topic
Reply
