>
New Topic
>
Reply<
Esato Forum Index
>
Sony Ericsson / Sony >
Technical
> T610 unlock; previous posts don't help
Bookmark topic
Hello,
(I searched the SE forum, but only 1 post has a $ solution, and none free...)
How do I unlock my SE T610 for free? I am with T-Mobile in the USA.
I hope u can help.
--
Posted: 2004-01-28 02:32:20
Edit :
Quote
Look harder next time.
call T-Mobile. It's so simple. One of the few providers that routinely gives out unlock codes.
========
-Must currently have an active account or an account that has been cancelled less than 90 days ago.
-The account must have at least 90 days of active service.
-The account must not be delinquent or in Write Off with an outstanding balance.
-There must be a calling card balance on the account. (There is no dollar amount requirement)
-The name on the request must be listed on the account as the billed party name, authorized user, or contact name.
NOTE: Only one unlock code will be issued per active line per 90 days
[ This Message was edited by: ESTOR on 2004-01-28 17:48 ]
--
Posted: 2004-01-28 18:45:18
Edit :
Quote
Hey Estor, did you know that you can't unlock a SONY Ericsson remotely?!?!? Those can only be done directly, via a cable and software. Nokia's are the only phones that can be unlocked remotely. So no, you couldn't "just call up and get the codes". At the very least, you'd have to take it into a service center. And leafgreen, check your PM's. I wrote you.
Ethan
--
Posted: 2004-01-28 22:55:42
Edit :
Quote
I need software to unlock my t610. I bought the t28 service cable, I didn't get any software with it and I don't want to pay for unlock credits. can anyone point me in the direction of some freeware unlock software.
Regards
Nick
--
Posted: 2004-12-12 13:21:16
Edit :
Quote
http://www.cellular-support.c[....]orials&t_op=showtutorial&pid=2
As well as the instructions on this page there are also links to the files you will need.
--
Posted: 2004-12-12 14:00:45
Edit :
Quote
Here is a very good guide.
http://www.myforum.lasyk.net/showthread.php?t=4533
--
Posted: 2004-12-13 16:02:46
Edit :
Quote
Quote:
On 2004-01-28 22:55:42, RMskater wrote:
Hey Estor, did you know that you can't unlock a SONY Ericsson remotely?!?!? Those can only be done directly, via a cable and software. Nokia's are the only phones that can be unlocked remotely. So no, you couldn't "just call up and get the codes". At the very least, you'd have to take it into a service center. And leafgreen, check your PM's. I wrote you.
You, sir, are completely and totally incorrect.
SonyEricsson phones do NOT require software and a cable to remove SIM locks. These can be undone by entering the correct code into the SIMLock menu in the service settings (>*
In addition, you can ALSO remove these locks via a cable and software, but for this functionality in particular, the cable and software are purely extraneous. Upgrading the firmware, modem flash, and GDFS require a cable.
Please do your homework next time.
-db.
--
Posted: 2004-12-15 01:15:42
Edit :
Quote
--
Posted: 2005-01-11 12:27:57
Edit :
Quote
Hi all, I'm based in the Caribbean.I bought my SE t610 off of amazon.com, it was a t-mobile phone, but I purchased it without the plan.
My local service provider unlocked and activated the phone and it worked fine. Now I've bought a SE P 900 and have transferred my sim card to that phone, the problem is that whever I try putting in another sim card into the t610 it is asking for a phone unlock code (not a sim unlock code)......that I don't remember. Don't worry it's not the manufacturer default... I tried that and every other code that I could think of that I may have put in. I even tried a master reset...... but to no avail. This phone works only with my sim card. My service provider has given me the PUK & IMEI and that dosen't work either, they've recommended that I take the phone back to t-mobile......but this really is not practical. Can anyone help me with a phone unlock code ?
--
Posted: 2005-01-11 12:40:46
Edit :
Quote
the default fone lock code is 0000. if u changed it, probably an se service will solve this problem.
--
Posted: 2005-01-11 17:19:41
Edit :
Quote
New Topic
Reply
