Sony Ericsson / Sony : General : help! (screen an keyboard not connected to circuit board after face change)
>
New Topic
>
Reply<
Esato Forum Index
>
Sony Ericsson / Sony >
General
> help! (screen an keyboard not connected to circuit board after face change)
Bookmark topic
hey im new to this but i was just lookin for phone info on the T610 i recently changed the face on mine WHAT A NIGHTMARE i ended up breaking the thing and now the screen isnt connected to the rest of the circuit board if thats what its called and nor is the keypad! i have it insured but it doesnt cover bein a dumbass n breaking it yourself!! is there any way of fixing it myself cos i reckon it wud cost quite abit if i took it into a shop! its a wreck!
[ This Message was edited by: masseur on 2004-07-26 18:25 ]
--
Posted: 2004-07-26 19:05:06
Edit :
Quote
The screen simply connects to the phone via a little plug type thing. Just push the small cable coming out of the LCD back into where it goes.
The keyboard simply sits on 4 pins around the edges. Put the keyboard back in place, push the 4 pins through the 4 holes and put the front facia back on.
Its not broken, unless of course you broke the cable coming out of the LCD.
--
Posted: 2004-07-26 19:23:51
Edit :
Quote
Yes, the little cable just slots into that black connector on the motherboard. Simply lift up the metal part of it, so that the black part of the connector slides out, insert the cable for the screen (same goes for the keyboard one), and with a bit of firm pressure and wiggling (NOT too hard though!) it should slot in. Then press down the metal part of the connector, which should hold it in place.
Voila! You (should) have a working screen and keyboard!
If you're unsure about this, take it to a service centre or to a local phone shop to get it sorted. They shouldn't charge you too much.
--
Posted: 2004-07-26 19:45:47
Edit :
Quote
New Topic
Reply
