Esato Forums - Sony Ericsson / Sony : GPRS, WAP, MMS and Email setup : Bluetooth connection to Ipaq

Index Menu

> New Topic
> Reply
< Esato Forum Index > Sony Ericsson / Sony > GPRS, WAP, MMS and Email setup > Bluetooth connection to Ipaq Bookmark topic

shark0 Posts: 27

I cannot seem to get the bluetooth to work connecting to my ipaq with my K700i, is there some special connection string i need.

[ This Message was edited by: shark0 on 2004-10-25 20:54 ]
--
Posted: 2004-10-25 21:52:55
Edit : Quote

masseur Posts: > 500

yes, since the K700 R2L firmware you need to add a z into the ipaq init string

_________________
...Unless I'm very much mistaken
my K700 review

[ This Message was edited by: masseur on 2004-10-25 20:54 ]
--
Posted: 2004-10-25 21:54:10
Edit : Quote

shark0 Posts: 27

Great that worked, why would they change this, is it suppose to be an enhancement or something.
--
Posted: 2004-10-25 21:57:52
Edit : Quote

masseur Posts: > 500

when I upgraded to R2L and it stopped working I spoke to SE techo's and they were as surprised as I was. I am sure it was not planned

btw in case you don't know what the Z does, the reason this works is that the Z in the init string follows the AT (attention) command issued to the K700 modem and that ATZ is a modem initialise command.

so my guess is that in R2L they changed something that caused the K700 modem not to initialise at the start of each dial out

I must remember to remove that Z and try again on the next firmware update!
--
Posted: 2004-10-25 22:09:07
Edit : Quote

Atlis Posts: > 500

Trully, I was thinking about it a bit - the problem is in Ipaq, 'cause there was no problem with Tungsten T3. Btw - masseur, do you have R2AA? Is this z adding still necessary? I didn't try it yet :-l This message was posted from a K700i
--
Posted: 2004-10-25 22:12:57
Edit : Quote

boto43 Posts: > 500

Quote:
On 2004-10-25 22:12:57, Atlis wrote:
Trully, I was thinking about it a bit - the problem is in Ipaq, 'cause there was no problem with Tungsten T3. Btw - masseur, do you have R2AA? Is this z adding still necessary? I didn't try it yet :-l

This message was posted from a K700i
its changing the problem with fw of K700 and its the problem of ipaq.

It doesnt seem to me.
--
Posted: 2004-10-25 22:37:23
Edit : Quote

shark0 Posts: 27

It must be an Ipaq problem, as I tested it with my Tablet pc with bluetooth, and that does not need the Z string to connect properly.

--
Posted: 2004-10-26 06:27:58
Edit : Quote

New Topic Reply