>
New Topic
>
Reply<
Esato Forum Index
>
Sony Ericsson / Sony >
Software, Firmware and Drivers
> Trying to connect
Bookmark topic
i have 2 credits with multiserver and a T28 cable.i have connected the cable to the com port and to the phone and then tried to "read CID" all that happens is a message to "Press on button of the phone shortly" and thern nothing happens.I disconnected the phone and the same message comes up.It is a brand new cable arrived this morning.What am i doing wrong?I even get the same message when i disconnect the cable from the COM port
Cheers
Here is the screen shot
[ This Message was edited by: andru on 2005-01-11 12:21 ]
--
Posted: 2005-01-11 12:41:18
Edit :
Quote
I'm guessing u set the com port up,.. Baud save etc
This message was posted from a K700i
--
Posted: 2005-01-11 13:32:55
Edit :
Quote
No all i set up in there was the 115200 speed which other do i have to set up for the cable to work?
--
Posted: 2005-01-11 13:39:17
Edit :
Quote
I only ever used data cable 4 sending stuff from t68i etc which was a while ago,try and get connectivity between fone/ pc first.
This message was posted from a K700i
--
Posted: 2005-01-11 14:23:22
Edit :
Quote
Take out the battery slightly, just one sec, then press on button again...
You soemtimes have to jiggle the battery, to get the server going....
--
Posted: 2005-01-11 15:21:14
Edit :
Quote
Thanks for the help i was just getting back to you.I have it sorted now the was a check box for "dtr" and "rts" i checked the dtr and it all worked.I now have a Unbranded with with new firmware
thanks for the replies
--
Posted: 2005-01-11 15:39:01
Edit :
Quote
New Topic
Reply
