News Forum Phone database

> New Topic
> Reply
< Esato Forum Index > Sony Ericsson / Sony > Symbian phones > Help my p910 touchscreen aint responding !! Bookmark topic

Hi i own a p910. Suddenly today my touchscreen stopped responding. Someone please help me Sunny This message was posted from a WAP device
--
Posted: 2005-07-30 14:42:24
Edit : Quote


try tu make a master reset hope it helps or first calibrate screen if it is possible This message was posted from a P900
--
Posted: 2005-07-30 14:47:45
Edit : Quote


Wow!3.threads.Take.it.to.SE.centre... This message was posted from a Nokia
--
Posted: 2005-07-30 14:50:26
Edit : Quote


How do i hard reset with keypad..too bad i've to use temporarily my mom's mob This message was posted from a WAP device
--
Posted: 2005-07-30 15:42:21
Edit : Quote


try to with jog dial >*> but I am not sure,
you must go to service menu
I've got it with jog dial
up*down,down*down*




This message was posted from a P900

[ This Message was edited by: boto43 on 2005-07-30 15:51 ]

[ This Message was edited by: boto43 on 2005-07-30 15:53 ]

[ This Message was edited by: boto43 on 2005-07-30 16:10 ]
--
Posted: 2005-07-30 16:48:31
Edit : Quote


Hi there.
I have just bought a P900 off of ebay, and it has the same problem with the touchscreen. I can't get to the Master reset option just with the jog dial. Is there another way to hard reset the P900? Thanks.
--
Posted: 2005-07-30 20:48:25
Edit : Quote


Hmm...other than the trip to a service centre...nope..
--
Posted: 2005-07-30 20:52:40
Edit : Quote


Come on. There has to be something out there other than expensive repair shop.
--
Posted: 2005-07-30 20:55:14
Edit : Quote


It's a long shot, but you could remove the front cover and check that the screen connector hasn't come partially unplugged? Especially as the touch function has gone altogether.

It's fairly easy, I've just changed a P900 screen.

Remove flip
Remove 4 screws on the back of phone; 2 under battery, other 2 under blanking tabs which are stuck on.
Run your thumb nail around the edge of the casing, it will unclip. Careful here, it is easy to mark the case, hence using my nail!
Fold the screen to the right; the connector is under the main PCB.
Remove 2 screws from shield plate.
You can now shift the PCB; be careful, the jogdial connector is on the left & pops off very easily. Just lift the board enough on the right to check the screen connector is fully seated!
--
Posted: 2005-07-31 00:58:16
Edit : Quote


I had the same problem recently, a P900 screen i changed wouldnt work with touch functionality - and it was fully plugged in.

I sent the screen back for a replacement, yet to receive another.
--
Posted: 2005-07-31 01:08:43
Edit : Quote

---

New Topic   Reply

Forum Index