>
New Topic
>
Reply<
Esato Forum Index
>
General discussions >
Non mobile discussion
> Monitor
Bookmark topic
Is it an old CRT monitor? as it sounds like a 'dry-joint' (bad solder connection breaks down after time)
Do you have a friend (male of course) that you can swap monitor with?
--
Posted: 2004-10-17 11:16:46
Edit :
Quote
It is a new sync master :-(
This message was posted from a T68i
--
Posted: 2004-10-17 11:19:51
Edit :
Quote
Swap to prove it’s the monitor and get it replaced under warranty
--
Posted: 2004-10-17 11:26:17
Edit :
Quote
Thx
This message was posted from a T68i
--
Posted: 2004-10-17 11:30:27
Edit :
Quote
I think this may have already been covered in another post - but is the monitor's setting's in control panel set to 'interlaced' rather than 'non-interlaced'? Interlaced refreshing means that evey other line of pixels is refreshed first, then the lines that were missed out by the first 'refresh' are then done. Sorry for the rather poor explanation there, but that could be what's causing the monitor to flicker more. Also check that the refresh frequency - I believe anything above 70Hz is flicker-free. It's in Control Panel>Display>Settings>Advanced button>then the Monitor tab.
If it's none of this or any other settings on your computer, and you say it's a new monitor, take it back to the shop you got it from and get it swapped.
--
Posted: 2004-10-17 11:32:13
Edit :
Quote
Thx wil chk it asap
This message was posted from a T68i
--
Posted: 2004-10-17 11:48:10
Edit :
Quote
Yes yes yes! Its solved
Guess the extension cord console was the culprit..i think it has gone bad
I made a direct connection and vioa a flicker free monitor.
Another thing: Has anybody of u been able to make the settings of ur monitor perfect? I.e. the pincushion, geometry (trapezoid, pin balance, etc.) Mine seems quite inperfect (disbalanced sort of ) if u know what i mean...
edit: it's started flickering again!!!!!!! Wtf is happening?? How cud this be? I constantly tried it
_________________
T610
Enuff said!
[ This Message was edited by: Ayush on 2004-10-17 12:48 ]
--
Posted: 2004-10-17 13:40:04
Edit :
Quote
hi ayush..
the monitor needs degaussing.. call up the samsung guy and ask him to do it.
--
Posted: 2004-10-17 14:13:00
Edit :
Quote
But i pressed the dugauss button..
--
Posted: 2004-10-17 14:18:06
Edit :
Quote
how old is the monitor though?
if its under warranty.. i don't think u have any reason to worry mate!
try whacking it a couple of times.
anyways.. here are the kolkata numbers for samsung.
Information Systems & Service
Mr. Sudip Paik
10A LEE ROAD, PRESSMAN SERVICES KOLKATTA-20 033-22834155/56/57 itcalcutta@samsungindia.com
SMART SERVICE
MR PROSANTA CHAKI
94, SALKIA SCHOOL ROAD, HOWRAH 3628 112233 HOWRAH@SAMSUNGINDIA.COM
[ This Message was edited by: plasmadog on 2004-10-17 13:42 ]
--
Posted: 2004-10-17 14:40:19
Edit :
Quote
New Topic
Reply
